Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Gearboxes
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
Mitsubishi Fuso

Mitsubishi Fuso's DUONIC is a six-speed, wet dual-clutch transmission used in Canter commercial vehicles. Identify the vehicle market, exact gearbox, clutch design and service history before using any diagnostic procedure. It is a different application from the Mitsubishi passenger-car TC-SST; parts, fluids and calibrations must not be assumed interchangeable. Fuso Canter specification.

Contamination and shift faults: US recall 14V-046

Fuso reported that insufficient cleaning during manufacture could leave debris in the automatic transmission fluid (ATF), potentially lodging in the clutch-control solenoid valve. The reported symptoms include abnormal shift noise, engine-speed flare between gears and inability to shift; an inoperative transmission or engine stall was possible. The US bulletin covers certain 2012–2014 FEC52, FEC72, FEC92 and FGB72 trucks with transmissions before serial ZG81964, but expressly says some vehicles in the described range do not require the campaign. Check the individual VIN and campaign completion. The campaign called for a defined flush and refill; where shifting problems already existed, the bulletin directed technicians to diagnose and repair them first. A flush is not a diagnosis or a universal remedy for every shift complaint. Fuso recall bulletin C1006610 / 14V-046.

ATF cooler hoses and loss of drive

Two documented issues have different causes and applicability. US recall 14V-605 concerned certain 2012–2015 FEC52, FEC72, FEC92 and FGB72 vehicles whose cooler hose could burst because of insufficient material strength. The specified campaign inspected the hose batch and replaced affected hoses. A separate Australian campaign, RC0414DUOCLAMP, concerned certain 2012–2013 vehicles in which insufficient clamp force could allow the ATF hose to separate from its steel pipe, especially in cold weather. Both could cause ATF loss and loss of drive. Check local campaign eligibility by VIN; a leak alone does not establish either recall defect. US recall 14V-605 report; Australian recall REC-001066.

Replacement clutch, software and coding

Service bulletin 14-004A addresses 2012-on Canters receiving a replacement DUONIC with the later waffle-type clutch. Fuso warned that the correct transmission-control software is needed for proper application pressure, and that clutch-type coding must match the hardware: a mismatch can prevent the high-temperature warning operating correctly and lead to clutch seizure. After transmission or clutch replacement, record the installed hardware and software, verify the correct coding, and perform the applicable initialization and checks using current manufacturer instructions. Do not copy settings from a different vehicle or assume that reinitialization repairs a mechanical or hydraulic fault. Fuso service information bulletin 14-004A.

Workshop approach

  1. Record the VIN, market, gearbox identification, current fault codes, live data and complaint conditions before clearing anything; establish whether relevant campaigns have been completed.
  2. For leaks or loss of drive, inspect the cooler hoses, clamps and associated pipework, and assess fluid condition and level using the correct model-specific procedure. Secure the vehicle and do not continue driving with significant fluid loss.
  3. Investigate abnormal shifts against the manufacturer's fault-tracing procedure, including electrical, hydraulic and mechanical causes. Correlate the symptoms with service and replacement history before attributing them to contamination or coding.
  4. Use the specified fluids and service procedures for the exact unit. The cited 2014 campaign distinguishes the dual-clutch housing ATF from gearbox oil; do not assume one fill or one specification applies to all DUONIC variants. Observe the applicable initialization requirements after service.

See also the electronic automated-manual and dual-clutch gearbox guide.