Standalone logger with GPS and inertial sensing, SD storage, analogue and frequency inputs, serial and CAN FD interfaces. GPS output is listed as 5 Hz; higher-rate raw data and sample rates depend on configuration and options.

Specifications and capabilities
The manufacturer lists up to 12 analogue inputs, four frequency inputs, CAN FD and legacy CAN. Check optional channels and configured sampling rates on the purchased unit. Manufacturer specifications and documentation.
Pinouts and cabling
The following tables transcribe Race Technology's DL1 FD connector diagram. The diagram depicts the connections on the rear of the unit. Its connector drawings are presented on that rear-panel view; it does not explicitly identify the mating-plug wire-entry view. Check the moulded contact numbers and the unit-specific manual before wiring, because the mating connector is a mirror image when viewed from its mating face. The manufacturer's drawing names the two 12-way connectors DTF13-12PA (A) and DTF13-12PB (B).
12-way connector A
| Contact | Manufacturer label | Contact | Manufacturer label |
|---|---|---|---|
| 1 | A1 | 7 | RPM low |
| 2 | A3 | 8 | GND |
| 3 | Rx 2 | 9 | CAN2 L |
| 4 | CAN2 H | 10 | Tx 2 |
| 5 | 12 V | 11 | A4 |
| 6 | 5 V Ref1 | 12 | A2 |
12-way connector B
| Contact | Manufacturer label | Contact | Manufacturer label |
|---|---|---|---|
| 1 | A5 | 7 | RPM GND |
| 2 | A7 | 8 | GND |
| 3 | F1 | 9 | F4 |
| 4 | F3 | 10 | F2 |
| 5 | RPM high | 11 | A8 |
| 6 | 5 V Ref2 | 12 | A6 |
Serial/CAN data connector
The manufacturer labels the following positions on the rear data connector. Positions 4, 6 and 9 are shown without a function label; their assignment has not been verified. The diagram calls position 7 “+V” without specifying its voltage or current rating: confirm both with Race Technology before using it.
| Contact | Manufacturer label |
|---|---|
| 1 | CAN1 L |
| 2 | Rx 1 |
| 3 | Tx 1 |
| 5 | GND |
| 7 | +V |
| 8 | CAN1 H |
The manufacturer connection reference describes A1–A8 as analogue inputs and F1–F4 as frequency inputs; optional channels A9–A12 share the F1–F4 positions when that option is fitted. The low-level RPM input must not be connected directly to an ignition coil. Confirm the connector assignments, fitted options and electrical limits for the actual unit before wiring; disconnect power before changing connections.
The manufacturer's sources disagree on supply and sensor-output limits: its connection reference states 10–15 V and 1 A for each 5 V output, while its product specification states 10–23 V and 500 mA per 5 V output. Confirm limits for the exact hardware with Race Technology.
Wiring overview
Return to the Race Technology manufacturer page.