Peugeot Boxer and Citroën Jumper/Relay diesels span different engine and ECU generations, including shared commercial-vehicle platforms. Examples below are sourced application leads rather than a complete fitment list. Record VIN, market, engine code, vehicle year, gearbox, ECU label and read identification; displacement or model name alone is not sufficient to select a file or programming route.
Early HDi and 2.2 DCU102
AutoTuner's Peugeot catalogue lists first-generation facelift Boxer examples with Bosch EDC15C7, including 2.2 HDi 100 and 2.8 HDi 128/146. These are vendor catalogue examples; verify the installed ECU and exact calibration rather than assuming all 2.2 or 2.8 vans are identical.
AutoTuner's DCU102 release identifies Visteon DCU102 applications among selected 2.2 HDi Jumper and Boxer vehicles, including a 2006 example. Its tool advertises OBD virtual read and boot normal read, with calibration readout. A virtual read is a matched reference file, not evidence of a direct read of all vehicle-specific memories; even a normal calibration read does not by itself establish a full ECU recovery image. Check tool, software, read areas and recovery requirements for the unit.
2.2 HDi SID208
Alientech's August 2026 KESS3/Powergate release advertises OBD reading and writing for supported Continental SID208 2.2 HDi Boxer and Jumper/Relay applications from 2011, alongside its existing bench method. It is a vendor- and protocol-specific support statement, not proof that every 2.2 van has SID208 or that every tool has identical coverage. Confirm the current support list and exact read coverage before writing.
2.0 and 2.2 BlueHDi examples
Microtronik's DCM6.2C coverage lists 2.0 BlueHDi Boxer examples and advertises OBD read/write and an open-ECU boot method for HexProg II. A KESS3 release reproduced by Tuning-X lists Delphi DCM7.1B boot programming for selected 2019-model-year 2.2 BlueHDi Boxer/Jumper versions. Do not confuse DCM6.2C, DCM7.1B and DCM7.1A definitions or methods.
For later examples AutoTuner lists 2024 Boxer and Jumper 2.2 BlueHDi EU6e with Bosch MD1CS199. Its advertised route is mail-in unlock followed by its bench normal read/write protocol; unlock, read areas and access depend on the exact unit and provider. Vehicle year alone does not prove fitment or compatibility.
Diagnostics and calibration practice
Establish the baseline with the correct diagnostics, and compare requested and measured boost and rail pressure, airflow, temperatures, faults and aftertreatment state under comparable conditions. Identify the actual turbo, sensor range, gearbox and vehicle load before interpreting torque or air-path changes. Keep aftertreatment and diagnostic systems operational. Commercial file advertisements and generic gains are not validated values for a different van.
Check whether the tool reads calibration, internal/external flash, EEPROM and other vehicle-specific data as applicable. Record the tool's checksum support and a tested recovery plan for the exact ECU; an OBD write or identification alone does not prove the ability to restore the vehicle. See the PSA HDi and BlueHDi passenger-car guide, older rotary-pump diesel guide and PSA ECU identification overview.