Older Peugeot and Citroën diesels include mechanical injection pumps and electronically managed rotary-pump systems. Identify the engine code, exact pump maker and part number, ECU where fitted, vehicle and emissions equipment before choosing service information or considering tuning. These systems do not all use the same controls and cannot be treated as interchangeable with common-rail HDi.
Identify the injection system first
Citroën's XM technical summary lists three distinct examples: the 2.1 Turbo D XUD11 ATE/L with a mechanical pump; XUD11 BTE/L with Lucas Diesel EPIC electronic injection; and 2.5 Turbo D DK5 ATE/L3 with Bosch MSA 11 7.6 and VP36 electronic injection. The document concerns specific multiplexed XM versions and model years; it is not an all-market year cutoff or proof that every XUD pump is mechanical.
1.9 XUD turbo diesel: Bosch pump discussion
A Peugeot 405 owner tutorial identifies its example as a 1.9 XUD9/TE with a Bosch pump. It discusses the boost-responsive diaphragm and LDA cone, fuel delivery and turbo pressure; another participant reports a Lucas-equipped 306. These are individual community claims: the adjustments, quoted pressure limits and performance assertions are not independently verified and do not establish safe settings or apply to Lucas pumps.
Before any pump or boost changes, document the original configuration and service condition, including fuel and intake leaks, cooling, actuator operation and actual boost. A pump specialist can verify timing and delivery against the exact pump specification. Record smoke and temperature under comparable load; visible smoke or the author's perceived gain alone does not validate fuelling, exhaust temperature or reliability. Keep applicable emissions equipment operational.
1.9 DW8B: mechanical pump with electronic timing control
A French vocational diesel examination technical dossier describes a DW8B Lucas DCN2 mechanically driven pump with electronic management. The controller handles functions including injection advance, EGR and pre/post-heating. The load potentiometer is on the pump and the No. 1 injector carries a needle-lift sensor. A separate DW8 service workbook reproduction describes the needle-lift signal as start-of-injection feedback to the diesel control unit. These are distinct from a common-rail pressure control system.
For a timing or running fault, use the relevant vehicle-specific diagnostic and service procedure to assess the load signal, injector feedback, wiring and commanded advance alongside mechanical timing and fuel supply. An ECU in the system does not prove the pump has a conventional common-rail tune or that an HDi definition can be applied.
Electronically managed XUD and DK5
The XM examples above distinguish Lucas EPIC and Bosch VP36 systems. Record the pump and controller identities, vehicle configuration, fault codes and current service procedures before deciding whether electronic programming, mechanical repair or specialist pump work is relevant. Do not infer map locations, flash access or wiring from a similar-displacement engine.
For later common-rail vehicles see the PSA HDi and BlueHDi diesel tuning guide and Boxer and Relay diesel guide. The PSA ECU identification overview links related petrol and diesel material.