The standard Solo 2 is a GPS lap timer and logger with an integrated display and battery. Unlike Solo 2 DL, it does not connect to the ECU for vehicle channels. For the range overview see AiM in-car dataloggers.

Specifications
| Item | Specification |
|---|---|
| GNSS and motion | 25 Hz GNSS; internal three-axis accelerometer and gyroscope |
| Display | 238 × 99 graphical display; up to five configurable pages |
| Memory / power | 4 GB internal; rechargeable lithium battery; 9–15 V external |
| Communications | Wi-Fi; no ECU connection |
| Enclosure | 98 × 73.7 × 30.2 mm; IP67 |
Specifications and kit contents: AiM Solo 2 technical documentation. Check hardware generation and exact kit.
Pinout
On standard Solo 2, AiM's five-pin Binder 712 female EXP connector external view has the assignments below. This is not the Solo 2 DL expansion pinout. See AiM technical sheet, page 4.
| Item | Specification |
|---|---|
| 1 | Not connected |
| 2 | Ground |
| 3 | Not connected |
| 4 | Not connected |
| 5 | +Vb external |
Wiring and installation
AiM lists a car-lighter power cable and AC battery charger. A 5-pin plug is not evidence of an ECU connection. Do not apply the Solo 2 DL EXP CAN assignments to this unit.
Choose the correct Solo 2 power lead and configure the device in Race Studio 3. Confirm every cavity number, signal level, ground, power source and electrical limit in the linked AiM documentation before wiring; diagrams are from the device view or a conceptual schematic as stated. Secure the loom and make connections with power disconnected.
Software and further reading
Use AiM Race Studio 3 to configure supported devices and analyse recorded sessions. The standard Solo 2 does not record ECU channels; select the DL variant if an appropriate ECU connection is needed. Manufacturer references: model documentation; product and installation guidance.