Davis Technologies TC-3 · Davis Technologies traction control systems
Scope and identification
This table transcribes the P1 20-gauge, 14-position connector in the manufacturer’s TC-3 instructions, printed page 18. Refer to the source connector illustration to identify pin numbering and orientation on the actual harness. Confirm controller version, ECU integration and optional features before wiring; do not transfer this table to other controllers solely because their plugs look alike.
P1 assignments
| Pin | Wire colour | Function | Source flag |
|---|---|---|---|
| 1 | Red | Battery positive / ignition switch | |
| 2 | Yellow with black stripe | CAN low | * # |
| 3 | Green | Driveshaft RPM VR sensor input + | * # |
| 4 | White | Driveshaft RPM input | |
| 5 | Orange with black stripe | Transbrake sync input | |
| 6 | Tan | Arming switch | |
| 7 | Orange with white stripe | Analog input | * |
| 8 | Black | Battery ground | |
| 9 | Yellow with red stripe | CAN high | * # |
| 10 | White with black stripe | Driveshaft RPM VR sensor input − | * # |
| 11 | Orange | Driveshaft RPM output | * |
| 12 | Blue | Launch sync trigger output, 750 mA, Pos-Neg (manufacturer wording) | * |
| 13 | Light green | Correction output | |
| 14 | Gray | SmartDrop output |
* = Optional/future-use wire supplied but not installed in the connector, as described in the manual. # = twisted pair. VR means variable reluctance; RPM means revolutions per minute. These markings describe the manual's configuration, not a guarantee that any given used harness is populated as supplied.