Tuning Wiki

Davis Technologies TC-3 · Davis Technologies traction control systems

Scope and identification

This table transcribes the P1 20-gauge, 14-position connector in the manufacturer’s TC-3 instructions, printed page 18. Refer to the source connector illustration to identify pin numbering and orientation on the actual harness. Confirm controller version, ECU integration and optional features before wiring; do not transfer this table to other controllers solely because their plugs look alike.

P1 assignments

PinWire colourFunctionSource flag
1RedBattery positive / ignition switch
2Yellow with black stripeCAN low* #
3GreenDriveshaft RPM VR sensor input +* #
4WhiteDriveshaft RPM input
5Orange with black stripeTransbrake sync input
6TanArming switch
7Orange with white stripeAnalog input*
8BlackBattery ground
9Yellow with red stripeCAN high* #
10White with black stripeDriveshaft RPM VR sensor input −* #
11OrangeDriveshaft RPM output*
12BlueLaunch sync trigger output, 750 mA, Pos-Neg (manufacturer wording)*
13Light greenCorrection output
14GraySmartDrop output

* = Optional/future-use wire supplied but not installed in the connector, as described in the manual. # = twisted pair. VR means variable reluctance; RPM means revolutions per minute. These markings describe the manual's configuration, not a guarantee that any given used harness is populated as supplied.

Source

Davis Technologies TC-3 instructions, printed page 18.