Audi identifies the transmission controller as J217; on the 09E six-speed automatic it forms part of the transmission's mechatronic assembly. Audi's self-study programme 385 associates 09E with ZF 6HP26 A61 and Audi designation AL600-6Q. J217 is a functional identifier used on other transmissions too, not one universal hardware part number.

Identification and application
Audi's SSP 385 says 09E first appeared in the A8 2003 type 4E and discusses later applications. A related 09L is a different listed gearbox, although both use J217 as a control-unit designation. Read the actual VAG part number, software and hardware numbers, gearbox code and VIN rather than treating J217, 09E or AL600 as an interchangeable controller ID. The same programme describes mechatronic generations and immobiliser differences; check the vehicle-specific service data and control-unit version before replacement.
The 2008 Audi S8 service description identifies a black 16-way T16c connector for J217 in its 09E/09L section. Audi workshop information for an A6 3.2 BKH 2007 describes the TCM as part of the mechatronic.
Connector and pinout evidence
The cited A6 3.2 BKH 2007 workshop test identifies T16c terminal 13 in its ground-resistance test and terminals 11 and 14 in an ignition-on battery-voltage test. These are test observations in the quoted 09E/09LA workshop procedure, not an independently measured programming pinout. The same reproduced procedure lists terminal 16 in both the voltage and the ground tests. Because that is contradictory, this page does not assign a function to terminal 16. Obtain the factory VIN-specific wiring diagram, numbered connector and face orientation before connecting power; Jaguar, BMW or other 6HP pinouts must not be transferred to this unit.
Recalibration tools
PCMflash's manufacturer manual, module 83 lists VAG ZF 8HP and AL420/AL600 09L/09E functions, marking relevant AL420/AL600 protocols as test in its English distributor list and describing virtual read/write/checksum. Check the current supported functions, required protocol, diagnostic interface and exact hardware/software before use. A virtual read is not a full direct read of the particular TCM, and a flash tool does not by itself supply a suitable calibration.
Dealer repair, immobiliser adaptation, replacement coding and aftermarket tune flashing are distinct operations. Audi SSP 385 discusses immobiliser-dependent mechatronic replacement; follow the exact factory procedure, preserve the existing coding and identification, and use the tool supplier's recovery procedure.
See ZF 6HP gearbox types and controllers. Sources reviewed 17 November 2026.