Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Datalogging and telematics
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
AiM

The standard Solo 2 is a GPS lap timer and logger with an integrated display and battery. Unlike Solo 2 DL, it does not connect to the ECU for vehicle channels. For the range overview see AiM in-car dataloggers.

AiM Solo 2
AiM Solo 2. Image: AiM, reproduced with permission; AiM product picture library.

Specifications

ItemSpecification
GNSS and motion25 Hz GNSS; internal three-axis accelerometer and gyroscope
Display238 × 99 graphical display; up to five configurable pages
Memory / power4 GB internal; rechargeable lithium battery; 9–15 V external
CommunicationsWi-Fi; no ECU connection
Enclosure98 × 73.7 × 30.2 mm; IP67

Specifications and kit contents: AiM AiM Solo 2 technical documentation. Check hardware generation and exact kit.

Pinout

On standard Solo 2, AiM's five-pin Binder 712 female EXP connector external view has the assignments below. This is not the Solo 2 DL expansion pinout. See AiM technical sheet, page 4.

ItemSpecification
1Not connected
2Ground
3Not connected
4Not connected
5+Vb external

Wiring and installation

Solo 2 power and data paths
Solo 2 power and data paths; original Tuning Wiki illustration based on AiM documentation. Schematic diagrams do not show physical connector positions unless explicitly labelled.

AiM lists a car-lighter power cable and AC battery charger. A 5-pin plug is not evidence of an ECU connection. Do not apply the Solo 2 DL EXP CAN assignments to this unit.

Choose the correct model-specific lead and configure the ECU protocol in Race Studio 3. A connector shape alone does not establish vehicle compatibility. Confirm every cavity number, signal level, ground, power source and electrical limit in the linked AiM documentation before wiring; diagrams are from the device view or a conceptual schematic as stated. Secure the loom and make connections with power disconnected.

Software and further reading

Use AiM Race Studio 3 to configure supported devices and analyse recorded sessions. Check the specific ECU protocol and cable before connection; not every source exposes every channel. Manufacturer references: model documentation; product and installation guidance.