GS19.11 is a control-unit designation used in selected ZF 6HP28 mechatronics. Jaguar shift-by-wire and Land Rover mechanical-shift versions must be identified separately.


Identification and examples
Jaguar specialist Old Jaguar lists Bosch 0260550043 / ZF 6058007115 for the GS19.11 E-shift 6HP28 and cites Jaguar X150, X250 and X351 examples. Its mechanical-shift Land Rover example lists different numbers, including Bosch 0260550041. The specialist's listing is not a guarantee of interchange: verify model year, engine, hardware and software ID, selector, VIN and gearbox specification.
A 2010 Jaguar XF 5.0 SC service description identifies a 6HP28 with integrated TCM/mechatronic, rotary selector and electronic park lock. It does not identify a Bosch number, so it is an application example, not proof that every 2010 XF uses 0260550043.
Jaguar 6HP26/28 shift-by-wire connector example
The 16-way gearbox connector assignments below are transcribed from William Henney's 6HP26 training presentation, specifically its “Jaguar 6HP26/28 with shift-by-wire” table. The presentation does not associate the table with a specific Bosch number or VIN and does not clearly state connector-face orientation. It gives a numbered connector photograph: check that and the actual VIN-specific wiring document and moulded cavity numbers before connecting. These are documented assignments for the described example, not independently bench-verified or a guaranteed pinout for this particular controller number. “Not used” applies to the source example only.
| Cavity | Function in source example |
|---|---|
| 1 | Not used in source example |
| 2 | CAN low |
| 3 | ISO K (example application) |
| 4 | Not used in source example |
| 5 | Not used in source example |
| 6 | CAN high |
| 7 | Not used in source example |
| 8 | LIN selector-position information |
| 9 | Terminal 15 wake-up |
| 10 | Park / no-park signal |
| 11 | Not used in source example |
| 12 | Not used in source example |
| 13 | Terminal 31-1 ground |
| 14 | Terminal 30 permanent positive |
| 15 | Not used in source example |
| 16 | Terminal 31-2 ground |
The same presentation's mechanical-selector example has different functions at cavities 1, 4, 5 and 8. Do not transfer these values to mechanical-shift Jaguar, Land Rover, BMW or another car without its own wiring evidence.
Programming and recalibration
PCMflash lists Jaguar/Land Rover 6HP26/28 in module 81's manual, with reading, writing and checksum for specific TCM families. Magicmotorsport FLEX lists selected 6HP bench duplication in its duplicable units list; duplication alone does not prove calibration editing for this exact number. Check the current tool's vehicle, ECU identity, protocol and required licence. A calibration editor or service is separate from the device that reads and writes a file.
Use manufacturer-prescribed service configuration and a recovery plan when replacing the TCM. A compatible blank or used controller may require application-specific software and setup; match the vehicle and preserve its original identification and configuration before changing anything.
See ZF 6HP gearbox types and controllers. Sources reviewed 17 November 2026.