Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Engine ECU
Parent
AEM EMS Series 2
Applies to
AEM EMS Series 2
Tool groups
None
Manufacturers
None

The AEM EMS Series 2 30-6030 is an application-specific plug-in engine management system. It uses the vehicle connector assignments shown in its own manufacturer installation manual; other Series 2 part numbers must not be assumed to share this schedule.

AEM 30-6052 shown as a Series 2 family illustration; connectors and applications can differ
AEM 30-6052 shown as a Series 2 family illustration; connectors and applications can differ. Source: AEM / Holley product listing; reproduced with permission.

Applications and identification

The manual cover lists 2002–2004 Acura RSX (K20A2/K20A3) and 2002–2004 Honda CR-V (K24A1). Its connector chart additionally names 2001–2005 Civic D17 and Civic Si K20A3; the cover and chart differ, so verify part number and vehicle compatibility with AEM before installation.

Connector pin assignments

The following tables transcribe the connector schedule in the AEM 30-6030 installation manual, PDF pages 13, 14, 15, 16, 17. The manufacturer labels each position with its original vehicle function and its EMS function, I/O direction and notes, with vehicle wire colours. Follow the connector diagram and viewing orientation in that manual. A dash reflects the manufacturer’s entry and does not by itself establish an unused or safe connection. Where a channel is configurable, its actual use also depends on the wiring and calibration.

Connector A

PinOriginal vehicle functionWire colourAEM EMS functionI/OManufacturer notes
A1Primary O2 sensor heater controlBlack/White (Green for D17A6)Low Side 1OutputAvailable, switched ground, 1.5A max
A2Ignition Power 2Yellow/BlackIgnition PowerInputDedicated, +12V power for EMS
A3Ignition Power 1Yellow/BlackIgnition PowerInputDedicated, +12V power for EMS
A4Power Ground 2BlackPower GroundInputDedicated, ground for EMS
A5Power Ground 1BlackPower GroundInputDedicated, ground for EMS
A6Primary O2 sensor signalRed (White for D17A1, D17A2)O2 #1InputAvailable, 0–5V O2 sensor #1 (connected to C13)
A7Crankshaft position sensorBlueCrank (T1)InputDedicated, crank position sensor (T1)
A8Intake manifold runner control sensor (2002–2004 RSX K20A3 and 2002–2004 CRV K24A1 only)Red/Yellow (K20A3/K24A1) (Yellow for D17)MAFInputAvailable, 0–5V mass airflow sensor
A9Knock sensorRed/BlueKnock 1InputPnP for knock sensor
A10Sensor ground 2Green/YellowSensor GroundOutputDedicated, sensor ground
A11Sensor ground 1Green/WhiteSensor GroundOutputDedicated, sensor ground
A12Idle air control valveBlack/RedPW 1OutputPnP for idle air control valve
A13EGR valve position sensor (2001–2005 Civic D17A2/D17A6 only)White/BlackKnock 2InputAvailable, knock sensor 2
A14Secondary O2 sensor heater control (2001–2005 Civic D17A1/D17A6 only)Black/White---------
A15Throttle position sensorRed/BlackTPSInputPnP for throttle position sensor
A16Primary O2 sensor groundRed/YellowSensor GroundOutputDedicated, sensor ground
A17------Idle 2OutputAvailable, switched +12V power, 1.5A max
A18Vehicle speed sensorWhite/GreenSpare Speed (T4)InputPnP for vehicle speed sensor
A19Manifold absolute pressure sensorGreen/RedMAPInputPnP for manifold absolute pressure sensor
A20+5V sensor power 2Yellow/Blue+5V SensorOutputDedicated, +5V sensor power
A21+5V sensor power 1Yellow/Red+5V SensorOutputDedicated, +5V sensor power
A22O2 sensor heater controlWhiteHigh Side 2OutputAvailable, switched +12V power, 1.5A max
A23Logic ground 2Brown/YellowPower GroundInputDedicated, ground for EMS
A24Logic ground 1Brown/YellowPower GroundInputDedicated, ground for EMS
A25Camshaft position sensor A (K-series) Secondary O2 sensor heater (2001–2005 Honda Civic D17A1/D17A6 only);Blue/White (White/Red for D17)Vehicle Speed (T3)InputAvailable, 0–5V vehicle speed sensor
A26Camshaft position sensor BGreenCam (T2)InputDedicated, camshaft position sensor (T2)
A27Ignition pulse no. 4BrownCoil 4OutputPnP for coil 4
A28Ignition pulse no. 3White/BlueCoil 3OutputPnP for coil 3
A29Ignition pulse no. 2Blue/RedCoil 2OutputPnP for coil 2
A30Ignition pulse no. 1Yellow/GreenCoil 1OutputPnP for coil 1
A31------Idle 8OutputAvailable, switched +12V power, 1.5A max

Connector B

PinOriginal vehicle functionWire colourAEM EMS functionI/OManufacturer notes
B1VTC oil control solenoid valve high side (except 2001–2005 Honda Civic D17A1/2/6)Blue/WhiteHigh Side 3OutputPnP for VTC solenoid (Variable Valve Timing control)
B2No. 4 InjectorYellowInjector 4OutputPnP for Injector 4
B3No. 3 InjectorBlueInjector 3OutputPnP for Injector 3
B4No. 2 InjectorRedInjector 2OutputPnP for Injector 2
B5No. 1 InjectorBrownInjector 1OutputPnP for Injector 1
B6Radiator Fan control relayGreenLow Side 8OutputPnP for Radiator Fan control
B7Reverse lock solenoid valve (2002–2004 Acura RSX K20A2/3 and 2001–2005 Honda Civic SI K20A3 only)GreenInjector 8OutputAvailable, switched ground, 1.5A max (connected to C5)
B8Engine coolant temperature sensorRed/WhiteCoolantInputPnP for coolant temperature sensor
B9VTEC oil pressure switch (except 2001–2005 Honda Civic D17A1)Blue/BlackSwitch 4InputPnP for VTEC oil pressure switch
B10Alternator L signalWhite/BlueEGT 1InputAvailable, jumper set for 0–5V input (connected to C8)
B11------EGT 2InputAvailable, jumper set for 0–5V input (connected to C9)
B12------EGT 3InputAvailable, jumper set for 0–5V input (connected to C10)
B13Alternator F signalWhite/RedEGT 4InputAvailable, jumper set for 0–5V input (connected to C11)
B14EGR valve control (2001–2005 Honda Civic D17A2/6 only)Blue/RedInjector 5OutputAvailable, switched ground, 1.5A max (connected to C2)
B15VTEC solenoid valve (except Civic D17A1)Green/YellowHigh Side 1OutputPnP for VTEC solenoid valve activation
B16------Injector 6OutputAvailable, switched ground, 1.5A max (connected to C3)
B17Intake air temperature sensorRed/YellowAITInputPnP for intake air temperature sensor
B18Alternator C controlWhite/GreenInjector 7OutputAvailable, switched ground, 1.5A max (connected to C4)
B19------Idle 3OutputAvailable, switched ground, 1.5A max
B20------Low Side 5OutputAvailable, switched ground, 1.5A max
B21Evaporative emission canister purge valveYellow/BlueLow Side 4OutputAvailable, switched ground, 1.5A max
B22Intake manifold runner control valve (2002–2004 Acura RSX/Honda CR-V only)Red/BlueLow Side 3OutputPnP for intake manifold runner control valve
B23VTC oil control solenoid valve low side (except 2001–2005 Honda Civic D17A1/2/6)Black/WhiteInjector 10OutputPnP for VTC solenoid (variable valve timing control, connected to C6)
B24------Idle 4OutputAvailable, switched +12V power, 1.5A max

Connector C

PinOriginal vehicle functionWire colourAEM EMS functionI/OManufacturer notes
C1------Permanent +12VInputDedicated, permanent +12V power
C2------Injector 5OutputAvailable, switched ground, 1.5A max (connected to B14)
C3------Injector 6OutputAvailable, switched ground, 1.5A max (connected to B16)
C4------Injector 7OutputAvailable, switched ground, 1.5A max (connected to B18)
C5------Injector 8OutputAvailable, switched ground, 1.5A max (connected to B7)
C6------Injector 10OutputAvailable, switched ground, 1.5A max (connected to B23)
C7------Injector 9OutputAvailable, switched ground, 1.5A max (connected to E21)
C8------EGT 1InputAvailable, jumper set for 0–5V input (connected to B10)
C9------EGT 2InputAvailable, jumper set for 0–5V input (connected to B11)
C10------EGT 3InputAvailable, jumper set for 0–5V input (connected to B12)
C11------EGT 4InputAvailable, jumper set for 0–5V input (connected to B13)
C12------PW 2OutputAvailable, switched ground, 1.5A max (connected to E10)
C13------O2 #1InputAvailable, 0–5V O2 sensor #1 (connected to A6)
C14------O2 #2InputAvailable, 0–5V O2 sensor #2 (connected to E2)
C15------Switch 1InputAvailable, switched input (connected to E11)
C16------Switch 2InputAvailable, switched input (connected to E12)
C17------Switch 3InputAvailable, switched input
C18------Timing GroundInputAvailable, timing ground
C19------PW 1iOutputAvailable, switched ground, inverted PW 1 signal
C20------PW 2iOutputAvailable, switched ground, inverted PW 2 signal
C21------CAN1HOutputDedicated, CAN1 high side
C22------CAN1LOutputDedicated, CAN1 low side

Connector E

PinOriginal vehicle functionWire colourAEM EMS functionI/OManufacturer notes
E1Immobilizer fuel pump relayGreen/YellowLow Side 11OutputPnP for fuel pump relay
E2Secondary O2 sensor signal (all except D17A1/6) Third O2 sensor (2001–2005 Honda Civic D17A6 only)White/Red (Red/Blue for K24A1)O2 #2InputAvailable, 0–5V O2 sensor #2 (connected to C14)
E3Logic ground 3Brown/Yellow------Not used
E4Sensor ground 3Pink (White/Green for K24A1)Sensor GroundOutputDedicated, sensor ground
E5Sensor voltage 3Yellow/Blue+5V SensorOutputDedicated, sensor power
E6Secondary O2 sensor heater control (all except D17A6) Third O2 sensor heater control (2001- 2005 Honda Civic D17A6 only)Black/White (White/Black for D17A1/6)Low Side 12OutputAvailable, switched ground, 1.5A max
E7Main relay controlRed/YellowMain RelayOutputDedicated, ECU activates main relay with switched GND
E8O2 sensor heater control relayOrangeLow Side 2OutputAvailable, switched ground, 1.5A max
E9Ignition switch signal 1Black/Yellow (Yellow/Black for Civic, CRV)Ignition SwitchInputDedicated, +12V Ignition switch signal from Ign key
E10------PW 2OutputAvailable, switched ground, 1.5A max (connected to C12)
E11------Switch 1InputAvailable, switched input (connected to C15)
E12------Switch 2InputAvailable, switched input (connected to C16)
E13------Coil 6OutputAvailable, switched ground, 1.5A max
E14Fuel tank pressure sensorLight GreenADCR 13InputAvailable, 0–5V sensor
E15Electrical load detectorGreen/RedADCR 11InputAvailable, 0–5V sensor
E16Power steering pressure switch signalLight Green/BlackSwitch 5InputAvailable, switched input
E17------Idle 5InputAvailable, switched ground, 1.5A max
E18Air conditioner clutch relayRedLow Side 6OutputAvailable, switched ground, 1.5A max
E19------Idle 6OutputAvailable, switched +12V power, 1.5A max
E20Evaporative emission bypass solenoid valveBlue/Red (Grey / Red for K24A1)Low Side 9OutputAvailable, switched ground, 1.5A max
E21Evaporative emissions canister vent shut valveLight Green/Red (White/Red for K24A1)Injector 9OutputAvailable, switched ground, 1.5A max (connected to C7)
E22Brake pedal position switchWhite/BlackSwitch 6InputAvailable, switched input
E23K-lineLight blue------Not used
E24SEFMJ (Instrument cluster multiplex communication)YellowMultiplexOutputDedicated, used to drive the air conditioning switch and coolant temperature gauge
E25------Idle 7OutputAvailable, switched ground, 1.5A max
E26Engine speed pulseBlueLow Side 7OutputPnP for Tacho signal – RPM pulse to instrument cluster
E27Immobilizer codeRed/Blue (White for K24A1)------Not used
E28------High Side 4OutputAvailable, switched +12V power, 1.5A max
E29Service check signalBrownADCR 14InputAvailable, 0–5V input
E30Write enable signalRed/White------Not used
E31Malfunction indicator lamp (MIL)Green/Orange (Green/White for K24A1)Low Side 10OutputAvailable, switched ground, 1.5A max

Documentation

AEM 30-6030 Series 2 installation instructions and wiring chart. AEM engine management support archive.