Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Tuning
Parent
Section level
Applies to
Bosch EDC15, Bosch EDC16C39, Bosch EDC16C9, Bosch VP44 injection pump and PSG16
Tool groups
None
Manufacturers
Saab

Start with the exact vehicle and ECU

Saab diesels use several engine-management systems. The TiD or TTiD badge, engine code or model alone does not establish the ECU, file layout or programming method. Record the model year, market, engine, gearbox, ECU and pump labels, part number and software before selecting a read or calibration. The examples below are source-scoped; they are not a complete application list.

  • 2.2 TiD D223L: Saab's 2001 9-3 EDC15 description describes an engine controller communicating with the VP44 pump controller. Its 2002 9-3 PSG16 overview describes a different control arrangement for D223L. Do not infer one from the other. See EDC15 and VP44 timing feedback and VP44 and PSG16.
  • 1.9 TiD: Saab identifies Bosch EDC16C9 for its 2006 9-3 example and EDC16C39 for its 2007 9-5 example; both workshop pages name Z19DH and Z19DTH and specify different calibration data. Z19DH is retained here as printed in those sources. ECU type varies with application; see EDC16C9 and EDC16C39.
  • 1.9 TTiD: Saab's TA248-0918 identifies the 9-3 MY2008–2010 Z19DTR as EDC16C39. Check an individual unit before identifying other TTiD versions.
  • 3.0 TiD V6: Saab's 2003 9-5 V6 workshop description identifies Denso ECD U2P common-rail management. It should not be treated as an EDC16 file.
  • 2.0 TiD and TTiD, later 9-5: Speedparts identifies an A20DTH 2.0 TiD application as Bosch EDC17C19; a MAGPro2 vehicle list identifies a 2010 A20DTR TTiD as EDC17CP21. Some tool lists use different EDC17 names for similar vehicles, so these are reported examples rather than a universal identification. Verify the ECU label and software.

What a calibration has to coordinate

In the documented 2006 EDC16C9 system, pedal position becomes a torque request; operating limits and air mass constrain the permitted fuel. The ECU coordinates injection pressure, duration and timing alongside boost control. Compare requested and measured values and understand the relevant limiters before editing: increasing one request alone does not establish that sufficient air, fuel-system capacity or drivetrain margin exists. Saab explains these relationships in its EDC16 description. The related diesel injection tuning overview, smoke limits and injection timing cover the general principles.

The 1.9 TTiD's turbo control must be assessed as its own system; Saab describes its arrangement in the Z19DTR turbocharger description. Do not transfer map addresses, scaling, or calibration values between files on the strength of an ECU-family name.

Baseline and read strategy

  1. Read faults and live data, then investigate air and boost leaks, vacuum control, fuel supply and rail-pressure tracking. Saab's limp-home bulletin gives application-specific diagnostic checks.
  2. Check oil condition and level, cooling system, exhaust aftertreatment and service history. For the Z19DTR range covered by TA248-0918, interrupted regenerations can dilute engine oil; follow the bulletin for the affected car. Saab also published a D308L coolant-loss bulletin.
  3. Use the programming tool's current instructions for the identified hardware and software. Establish whether the read contains calibration only or all recovery data, retain the original, verify checksum handling and the recovery route, and maintain stable programming voltage.
  4. Log the relevant requested and measured air mass, boost and rail pressure, temperatures and, where equipped and supported, particle-filter data. Judge results against the actual vehicle, transmission and operating conditions; advertised output is not a universal target.

Documents and community references

Related ECU catalogue entries

Browse source-scoped engine examples under Bosch EDC15M, Bosch PSG16, Bosch EDC16C9, Bosch EDC16C39, Bosch EDC17C19, Bosch EDC17CP21 and Denso ECD U2P. Existing catalogue records may have broader legacy scope; use the linked source and confirm the actual vehicle.