Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Gearboxes
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

MultiMode or M-MT identifies a Toyota automated manual transmission in the examples below. The clutch and gear changes are actuated electronically rather than by a clutch pedal. Toyota's AYGO introduction describes electric-motor actuation with automatic E and driver-requested sequential M modes; its Yaris material describes E, Es and M modes on that documented generation. These examples do not establish identical operation for every Toyota labelled MultiMode. Toyota AYGO press kit, p. 48; Toyota Yaris press kit, p. 50.

Identify the transmission and the event

Record the model, engine, build date, gearbox and transmission ECU, software, warning, selector mode and service history. Do not assume Toyota MultiMode is the same transmission as a Multidrive CVT, conventional automatic or later dual-clutch unit. When investigating a complaint, distinguish start refusal, no selected gear, unexpected neutral, shift interruption, clutch slip and a temperature warning.

Clutch warning example: AYGO

In the AYGO handbook identified as OM99L81E, a steady Multi-mode transmission warning signals a system malfunction. Its warning-and-buzzer indications distinguish a system malfunction with an overheated clutch from a flashing hot-clutch warning that the manual says does not by itself indicate a transmission-system fault. For those stated indications, Toyota tells the driver to stop safely, select N and wait approximately 15 minutes for cooling; the malfunction-and-overheat indication also calls for the system to be checked. Use the exact car's handbook: lamp meanings, prerequisites and actions may differ. Toyota AYGO owner's manual, warning lights.

Diagnosis and recorded data

  1. Preserve transmission and engine fault codes, status and available freeze-frame data before clearing memory or performing learning. Record the event, brake and selector inputs, operating mode and temperature.
  2. Using the correct diagnostic tool and wiring information, compare request with clutch, gear selection and engagement feedback, engine and transmission speed, supply voltage and relevant communication or interlock states where available. A symptom or actuator-circuit code alone does not prove a replacement actuator is needed.
  3. Inspect the clutch and release mechanism, actuator and position sensing, wiring, power supply and gear-selection system according to the fault-specific service procedure. A learning failure may reflect a physical or electrical fault rather than a need for repeated resets.

Initialization depends on the repair

Toyota service bulletin CP-4014, October 2004, for its stated European Corolla Verso application, distinguishes ECU, clutch and transmission initialization according to the parts repaired. It says calibration values and DTC history in the MMT ECU are not cleared simply by disconnecting the battery. It also identifies selector-position, engine-speed signal and CAN issues as possible avenues when initialization cannot be completed. These are bulletin-specific observations, not instructions to initialize every MMT.

Initialization can erase useful learned or fault information and may cause actuators to move. Follow the current repair procedure, diagnostic equipment and prerequisites for the exact vehicle and component work; do not copy a Corolla Verso sequence to AYGO or Yaris. A reset does not repair a worn clutch, wiring fault or mechanical problem.

See automated manual clutch and gearshift control, clutch operation and types and the gearbox catalogue.