MSPNP-Pro GNX8487 is a vehicle-specific MS3Pro-based plug-in engine management ECU. The manufacturer’s model-specific installation guide lists the following application: 1984–1987 Buick Regal Grand National. Fitment depends on the original ECU connector, engine, harness and market; confirm the exact part number before installation.
Application and installation
Check the engine harness and ECU connector against the installation guide. Plug-in does not mean every optional feature is prewired: follow the relevant guide for setup, sensors, jumpers, base tune and ignition-timing checks.
Pinout and documentation
AMP EFI GNX8487 vehicle-specific installation and connector documentation is the primary source for this model. Check the connector orientation, version and any configurable or optional functions before wiring. Diagrams may be shown as images in the guide; this page does not substitute a pin assignment from another MSPNP model.
See the manufacturer’s ECU documentation index and firmware and base-tune index. Initial maps require verification and tuning for the particular engine.
Rear options connector — A–Z
Transcribed from this application's AMP EFI installation guide. These are the rear options connections; they are not the complete factory vehicle connector pinout. Verify orientation, exact ECU variant, electrical limits and software configuration before wiring.
| Pin | Function | Default or note in source |
|---|---|---|
| A | Analog input 2 | Gear 1/2, 3, 4 detection |
| B | Knock sensor | — |
| C | DFIN3 | — |
| D | Analog input 1 | Optional wideband O2 |
| E | Digital input 1 | Optional flex fuel |
| F | CMP+ | — |
| G | CANL | — |
| H | 5 V Vref | — |
| I | CANH | — |
| J | Sensor return | — |
| K | Injector J | General-purpose output or high impedance only |
| L | High current 3 | — |
| M | Injector I | General-purpose output or high impedance only |
| N | High current 2 | — |
| O | Injector H | General-purpose output or high impedance only |
| P | Spark H | — |
| Q | Injector G | General-purpose output or high impedance only |
| R | Spark G | — |
| S | Injector F | High or low impedance |
| T | Spark F | — |
| U | Injector E | High or low impedance |
| V | Spark E | — |
| W | Injector D | High or low impedance |
| X | Spark D | — |
| Y | Injector C | High or low impedance |
| Z | Spark C | — |