Tuning Wiki
Applies to

Check the hardware and software limits stated in this article.

AMP MSPNP-Pro Subaru WRX ECU
MSPNP-Pro SW0205 Subaru WRX version shown as a family illustration; this application has its own case and connector layout. Image: AMP Engine Management, reproduced with permission.

MSPNP-Pro GNX8487 is a vehicle-specific MS3Pro-based plug-in engine management ECU. The manufacturer’s model-specific installation guide lists the following application: 1984–1987 Buick Regal Grand National. Fitment depends on the original ECU connector, engine, harness and market; confirm the exact part number before installation.

Application and installation

Check the engine harness and ECU connector against the installation guide. Plug-in does not mean every optional feature is prewired: follow the relevant guide for setup, sensors, jumpers, base tune and ignition-timing checks.

Pinout and documentation

AMP EFI GNX8487 vehicle-specific installation and connector documentation is the primary source for this model. Check the connector orientation, version and any configurable or optional functions before wiring. Diagrams may be shown as images in the guide; this page does not substitute a pin assignment from another MSPNP model.

See the manufacturer’s ECU documentation index and firmware and base-tune index. Initial maps require verification and tuning for the particular engine.

Rear options connector — A–Z

Transcribed from this application's AMP EFI installation guide. These are the rear options connections; they are not the complete factory vehicle connector pinout. Verify orientation, exact ECU variant, electrical limits and software configuration before wiring.

PinFunctionDefault or note in source
AAnalog input 2Gear 1/2, 3, 4 detection
BKnock sensor—
CDFIN3—
DAnalog input 1Optional wideband O2
EDigital input 1Optional flex fuel
FCMP+—
GCANL—
H5 V Vref—
ICANH—
JSensor return—
KInjector JGeneral-purpose output or high impedance only
LHigh current 3—
MInjector IGeneral-purpose output or high impedance only
NHigh current 2—
OInjector HGeneral-purpose output or high impedance only
PSpark H—
QInjector GGeneral-purpose output or high impedance only
RSpark G—
SInjector FHigh or low impedance
TSpark F—
UInjector EHigh or low impedance
VSpark E—
WInjector DHigh or low impedance
XSpark D—
YInjector CHigh or low impedance
ZSpark C—