
Dropbear is a complete Speeduino project ECU. The original V1 uses Teensy 3.5; the V2 uses Teensy 4.1 and USB-C and is not compatible with Teensy 3.5. The project documents eight high-impedance injector outputs, eight 5/12 V coil pre-drivers, six 2 A auxiliary outputs, onboard VR conditioning, CAN, optional stepper driver and an internal MAP sensor. SD logging requires suitable firmware. V2 wireless equipment depends on the fitted unit; the project guide describes an Airbear socket while WTMtronics' V2 listing describes onboard Wi-Fi and Bluetooth LE.
Connector pinouts
Two keyed Delphi Sicma 24-way connectors. Tables summarise the project manual; check its connector orientation, current limits, switches, and TunerStudio V1/V2 pin-number differences. Ignition outputs are logic pre-drivers, not direct high-current coil outputs. Fan and fuel pump outputs operate relays, not motors directly.
Black connector
| Pin | Function |
|---|---|
| A1 | Switched 12 V |
| A2 | Power ground |
| A3 | 5 V sensor reference |
| A4 | Not used |
| A5 | Spare digital input 2 |
| A6 | CAN L |
| A7 | CAN H |
| A8 | Power ground |
| B1 | Tachometer |
| B2 | Crank primary |
| B3 | Crank negative (VR only) |
| B4 | Cam primary |
| B5 | Cam negative (VR only) |
| B6 | Spare digital input 1 |
| B7 | Clutch input (ground switching) |
| B8 | Flex sensor |
| C1 | Analog sensor ground |
| C2 | Spare analog input 1 |
| C3 | Spare analog input 2 |
| C4 | Oxygen sensor input |
| C5 | Coolant sensor |
| C6 | Intake air sensor |
| C7 | Throttle position |
| C8 | External MAP input |
Grey connector
| Pin | Function |
|---|---|
| A1 | Injector 1 |
| A2 | Injector 2 |
| A3 | Injector 3 |
| A4 | Injector 4 |
| A5 | Injector 5 |
| A6 | Injector 6 |
| A7 | Injector 7 |
| A8 | Injector 8 |
| B1 | Ignition 1 |
| B2 | Ignition 2 |
| B3 | Ignition 3 |
| B4 | Ignition 4 |
| B5 | Ignition 5 |
| B6 | Ignition 6 |
| B7 | Ignition 7 |
| B8 | Ignition 8 |
| C1 | Boost |
| C2 | Fan relay |
| C3 | Spare 2 / stepper B2 |
| C4 | Idle / stepper B1 |
| C5 | VVT / stepper A1 |
| C6 | Spare 1 / idle 2 / stepper A2 |
| C7 | Fuel pump relay |
| C8 | Power ground |
Do not power offboard devices from sensor reference or analog ground; use documented fusing. External MAP input requires the selector set to external.
Confirm exact assembled revision, modifications, controller and firmware before wiring. Sensor conditioning and compatible drivers matter; see project hardware requirements.