Dropbear is a complete project ECU based on Teensy 3.5. The project documents eight high-impedance injector outputs, eight 5/12 V coil pre-drivers, six 2 A auxiliary outputs, onboard VR conditioning, CAN transceiver, optional stepper driver, replaceable internal MAP and onboard barometric sensor. SD logging requires firmware 202202 or later. V2 adds an Airbear socket for optional wireless communication.
Connector pinouts
Two keyed Delphi Sicma 24-way connectors. Tables summarise the project manual; check its connector orientation, current limits, switches, and TunerStudio V1/V2 pin-number differences. Ignition outputs are logic pre-drivers, not direct high-current coil outputs. Fan and fuel pump outputs operate relays, not motors directly.
Black connector
| Pin | Function |
|---|---|
| A1 | Switched 12 V |
| A2 | Power ground |
| A3 | 5 V sensor reference |
| A4 | Not used |
| A5 | Spare digital input 2 |
| A6 | CAN L |
| A7 | CAN H |
| A8 | Power ground |
| B1 | Tachometer |
| B2 | Crank primary |
| B3 | Crank negative (VR only) |
| B4 | Cam primary |
| B5 | Cam negative (VR only) |
| B6 | Spare digital input 1 |
| B7 | Clutch input (ground switching) |
| B8 | Flex sensor |
| C1 | Analog sensor ground |
| C2 | Spare analog input 1 |
| C3 | Spare analog input 2 |
| C4 | Oxygen sensor input |
| C5 | Coolant sensor |
| C6 | Intake air sensor |
| C7 | Throttle position |
| C8 | External MAP input |
Grey connector
| Pin | Function |
|---|---|
| A1 | Injector 1 |
| A2 | Injector 2 |
| A3 | Injector 3 |
| A4 | Injector 4 |
| A5 | Injector 5 |
| A6 | Injector 6 |
| A7 | Injector 7 |
| A8 | Injector 8 |
| B1 | Ignition 1 |
| B2 | Ignition 2 |
| B3 | Ignition 3 |
| B4 | Ignition 4 |
| B5 | Ignition 5 |
| B6 | Ignition 6 |
| B7 | Ignition 7 |
| B8 | Ignition 8 |
| C1 | Boost |
| C2 | Fan relay |
| C3 | Spare 2 / stepper B2 |
| C4 | Idle / stepper B1 |
| C5 | VVT / stepper A1 |
| C6 | Spare 1 / idle 2 / stepper A2 |
| C7 | Fuel pump relay |
| C8 | Power ground |
Do not power offboard devices from sensor reference or analog ground; use documented fusing. External MAP input requires the selector set to external.
Confirm exact assembled revision, modifications, controller and firmware before wiring. Sensor conditioning and compatible drivers matter; see project hardware requirements.