Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Engine ECU
Parent
Speeduino standalone ECUs
Applies to
Speeduino standalone ECUs
Tool groups
None
Manufacturers
None
Annotated Speeduino v0.3.2 shield
Speeduino v0.3.2 board. Image: Speeduino project, reproduced with permission.

The first widely available project shield targets many one- to four-cylinder port-injected engines. The project documents four injector and four ignition outputs, CLT, IAT, TPS and oxygen inputs, an optional crank/cam VR conditioner mount, MAP location and four medium-current spare outputs. Connections use screw terminals and a prototyping area permits additional circuits.

Pinouts and revisions

Use the v0.3 board manual, connector layout and revision list. Its firmware mapping table is explicitly numbered in Arduino Mega pins, not screw-terminal or IDC connector positions. The official board files provide hardware designs. Verify build and jumper setup; logic ignition outputs require appropriate coil drivers.

Confirm exact assembled revision, modifications, controller and firmware before wiring. Sensor conditioning and compatible drivers matter; see project hardware requirements.