Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Gearboxes
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Ti8HP is a forthcoming transmission interface for the Haltech Nexus ecosystem, announced in Haltech’s SEMA 2026 preview. Haltech says the gearbox’s own TCU continues to perform shift logic; Ti8HP connects it to a compatible Nexus ECU and reads the original transmission binary before flashing a Haltech binary through the Haltech system. It is an interface for a retained TCU, not an external solenoid controller.

Haltech Ti8HP transmission interface
Ti8HP interface shown in the manufacturer’s preview. Image and credit: Haltech. Permission to republish confirmed by the user.

Release status and identification

At the source review on 17 November 2026, Haltech planned a first-quarter 2027 release, with the date to be confirmed; it stated that pre-orders were not yet open. Planned capabilities can change. The manufacturer announcement includes product imagery and describes a supplied pre-terminated harness; confirm final part number, hardware, software and harness identification against the release documentation.

Planned gearbox and ECU support

Haltech lists 8HP45, 8HP70 and 8HP90 first-generation gearboxes for launch. It says second-generation support is planned later. This is a manufacturer plan, not confirmation that all donor vehicles, TCU hardware, calibrations or versions work. Check final support against the complete gearbox and controller identity.

Haltech lists Nexus R series, Nexus S series, Nexus Rebel and Nexus plug-in ECUs with electronic throttle control configured; it says T-series ECUs are not supported. A compatible shifter and brake-pedal input to the ECU are required. Supported selector examples in its preview include BMW F- and G-series and Toyota A90 Supra factory selectors, wired paddles, a CAN keypad and a resistor ladder. Confirm your particular ECU, harness, selector and firmware against final documentation.

Operation and installation scope

Haltech describes engine torque information, upshift torque reduction, downshift throttle opening, limited shift-point correction and transmission fault display in the ECU. It describes transbrake, clutch control and custom shift points as future aims, not launch guarantees. The supplier says its pre-terminated harness plugs into the transmission connection of compatible terminated harnesses and that the interface can be wired into another compatible drive-by-wire Nexus installation; follow its final wiring instructions.

Pinout

The preview does not publish a verified connector pinout or connector-face orientation. Do not infer terminal assignments from a different Haltech interface or a factory 8HP connector. Obtain the released Ti8HP and exact ECU/harness wiring documents before wiring or powering a unit.

See ZF 8HP gearbox controllers and ZF 8HP gearbox types. Source reviewed 17 November 2026.

Community guides and availability

No independent fitting report for Ti8HP was identified at the 17 November 2026 review. It had been previewed and Haltech's targeted release was the first quarter of 2027, so published compatibility and installation details were still subject to change. 8HP.info's Ti8HP guide collates the announced gearbox, ECU, throttle, shifter and brake-input requirements and links back to Haltech's SEMA preview; it is a summary of the announcement, not an installation test.

For an established but different way to connect a Haltech ECU to an 8HP, CANformance's installation manual lists Haltech integration with its separate CANTCU. Its wiring, firmware and retained-TCU arrangements must not be treated as Ti8HP instructions. Check the exact gearbox, ECU, supplier manual and torque-control configuration.