Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Flywheels
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

A performance flywheel changes the balance between rotational response, stored launch energy and drivability. Its effect depends on inertia, not only its advertised weight. Decide what the vehicle does, identify the engine and gearbox, and choose a complete, compatible clutch and flywheel combination with a suitable operating-speed limit. RAM: flywheel materials, weight and use.

Common approaches

  • Purpose-made steel flywheel: some aftermarket flywheels are machined from steel billet and offered with different masses or clutch interfaces. Material alone does not establish its speed or torque rating.
  • Aluminium flywheel with friction insert: some designs use a steel insert at the clutch contact face. Whether it can be replaced and the permitted hardware and fastener procedure depend on that product.
  • Single-mass conversion: replaces a DMF with a rigid flywheel and compatible clutch package. This changes vibration control as well as potentially changing inertia; see DMF-to-SMF conversions.
  • Machining an existing flywheel: material removal changes strength and balance as well as inertia. Do it only where the flywheel maker and a competent specialist explicitly permit the proposed work; do not use generic cut depths. Schaeffler says the friction surface of its DMFs must not be turned because the required burst speed is no longer assured. Schaeffler: DMF handling.

Driving and competition trade-offs

A lower-inertia assembly can make engine speed respond more quickly, but it stores less energy at the same rpm. Pulling away or recovering from a sudden load may need more precise control, and some combinations develop more audible gear rattle or stall more readily. Changes to clutch material, engine mounts and driveline damping can contribute too.

A road car used for traffic, hills or towing may value a smooth launch and vibration control; a light vehicle used for circuit work may place more value on fast speed changes. Neither outcome is guaranteed by a particular weight. Even in racing, the lightest option is not automatically fastest: launch rpm, gearing, tyre grip and vehicle mass affect whether stored energy helps avoid bogging or contributes to wheelspin. RAM: flywheel selection and launch.

Selection and verification

  1. Compare complete assembly inertia where available, not just catalogue kilograms. Check the maximum engine speed, clutch diameter, friction face and step, crank flange and starter interface.
  2. Check the clutch, fasteners, release system, sensor targets and gearbox input compatibility for the exact engine and transmission. Balance the assembly according to the engine and component manufacturers' instructions.
  3. Use appropriate containment and certification where a motorsport series requires them. Follow the component manufacturer's speed and service limits; a quoted material or appearance is not proof of strength.
  4. Assess idle, clutch engagement and noise before and after. A flywheel alone does not create steady-state engine horsepower; do not treat a transient dyno change as a universal gain.

See inertia and response, fitment and balancing and the flywheel overview. For ME7-specific stalling investigation, see ME7 lightweight flywheel and stalling.