Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Gearboxes
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Ti8HP is a forthcoming transmission interface for the Haltech Nexus ecosystem, announced in Haltech’s SEMA 2026 preview. Haltech says the gearbox’s own TCU continues to perform shift logic; Ti8HP connects it to a compatible Nexus ECU and reads the original transmission binary before flashing a Haltech binary through the Haltech system. It is an interface for a retained TCU, not an external solenoid controller.

Haltech Ti8HP transmission interface
Ti8HP interface shown in the manufacturer’s preview. Image and credit: Haltech. Permission to republish confirmed by the user.

Release status and identification

At the source review on 17 November 2026, Haltech planned a first-quarter 2027 release, with the date to be confirmed; it stated that pre-orders were not yet open. Planned capabilities can change. The manufacturer announcement includes product imagery and describes a supplied pre-terminated harness; confirm final part number, hardware, software and harness identification against the release documentation.

Planned gearbox and ECU support

Haltech lists 8HP45, 8HP70 and 8HP90 first-generation gearboxes for launch. It says second-generation support is planned later. This is a manufacturer plan, not confirmation that all donor vehicles, TCU hardware, calibrations or versions work. Check final support against the complete gearbox and controller identity.

Haltech lists Nexus R series, Nexus S series, Nexus Rebel and Nexus plug-in ECUs with electronic throttle control configured; it says T-series ECUs are not supported. A compatible shifter and brake-pedal input to the ECU are required. Supported selector examples in its preview include BMW F- and G-series and Toyota A90 Supra factory selectors, wired paddles, a CAN keypad and a resistor ladder. Confirm your particular ECU, harness, selector and firmware against final documentation.

Operation and installation scope

Haltech describes engine torque information, upshift torque reduction, downshift throttle opening, limited shift-point correction and transmission fault display in the ECU. It describes transbrake, clutch control and custom shift points as future aims, not launch guarantees. The supplier says its pre-terminated harness plugs into the transmission connection of compatible terminated harnesses and that the interface can be wired into another compatible drive-by-wire Nexus installation; follow its final wiring instructions.

Pinout

The preview does not publish a verified connector pinout or connector-face orientation. Do not infer terminal assignments from a different Haltech interface or a factory 8HP connector. Obtain the released Ti8HP and exact ECU/harness wiring documents before wiring or powering a unit.

See ZF 8HP gearbox controllers and ZF 8HP gearbox types. Source reviewed 17 November 2026.