Owners discussing HP Tuners on the 13th-generation F-150 with the 3.5 EcoBoost describe challenges interpreting boost and torque limits. One participant also discusses a 2021 F-150, a separate vehicle; do not assume its controller, parameters or thresholds match the earlier truck. The thread is a collection of owner experiences, not a validated calibration procedure. F-150 discussion.
Build a question-specific log
Connect VCM Scanner to the vehicle to establish its profile and choose channels available from that exact controller. For a pressure or load complaint, useful comparisons may include requested and actual throttle-inlet pressure, manifold pressure, requested and actual load, wastegate control, engine speed and intake or charge temperatures. Check signal labels, units and whether pressures are absolute or gauge before comparing. Availability, sensor position and definitions vary by calibration; do not assume that two similarly named PIDs are equivalent. HP Tuners: Scanner configuration.
In the forum, users advise keeping the channel list focused because excessive polling can slow data acquisition. Check the actual update rate, then use separate logs for different questions if needed. Record comparable conditions and review the time trace around the event rather than relying only on a peak number. F-150 logging discussion; HP Tuners: channel selector.
Protection and torque sources
The 2021 owner's report includes a protection-source indication, injector cut and misfire codes during a fault. Participants disagreed about the cause, and the accessible discussion does not establish a repair. A source flag shows what the controller reported at that moment; it does not on its own identify the underlying defect. Preserve the log and DTCs, investigate the engine and fuel system, and avoid repeatedly loading an engine that is misfiring or showing protection activity. Do not copy or disable the thresholds discussed in the thread. Owner report and replies.
Where available, HP Tuners' Torque Inverse Calculator relates Ford torque and air-load tables. An intercooler-change discussion in the same forum was unresolved; it does not establish a transferable table value. Begin from the vehicle's own read and verify software, hardware, licensing and instrument setup using the HP Tuners listing.