Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Gearboxes
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
Cadillac, Chevrolet, GMC

A 2009 Corvette C6 with a 6L80 was tuned using HP Tuners after a transmission rebuild. Its owner reported that manual upshifts worked but downshifts did not, and a scan tool showed a commanded gear without the expected mechanical response. The transmission had not been tested between the rebuild and the tune, so the original report could not isolate either as the cause. Corvette discussion.

Diagnose before changing shift tables

Record ECM and transmission diagnostic codes and the operating conditions. Compare driver request, commanded gear, available input/output speed or actual-gear information and the physical response. Check the transmission range and speed information, wiring and connectors, and assess hydraulic or mechanical condition with the correct service procedure. A command alone does not prove that the gear engaged.

The Corvette owner later reported an assessment suggesting a solenoid or valve-body issue and removed components for further work. The discussion does not document a final repair, and the scan or transmission was not independently inspected. It is a useful example of an unresolved fault, not evidence that every refused downshift needs a solenoid or a tune change. Source and follow-up.

After a tyre or final-drive change

On supported GM calibrations, VCM Editor's Edit > Gear/Tire Wizard adjusts speedometer calibration and can scale transmission tables for a different tyre size or final-drive ratio. HP Tuners specifies tyre height in inches even when metric units are displayed. Enter the actual applicable values, inspect the proposed changes, and validate speed and shift behaviour. HP Tuners distinguishes conventional rear-wheel-drive and Corvette transaxle procedures, so check the correct wizard options and the current instructions for the vehicle. Gear/Tire Wizard; GM speedometer calibration.

Tyre scaling is not a repair for an electrical, hydraulic or internal transmission fault. Confirm that the specific TCM is supported and licensed before attempting to write; consult the HP Tuners tool listing.