Scope: longitudinal 0B5 S tronic
Identify the exact transmission, vehicle and engine, control hardware, software and tune before interpreting logs or a definition. Audi's eSelf Study Program 950143 describes a particular 0B5 seven-speed S tronic design. It is a technical reference for that design, not proof that every longitudinal S tronic variant has the same controller, calibration or torque limits.
Audi describes torque reduction during its illustrated 1–2 shift, as well as input-speed sensing used for clutch slip and pressure monitoring. Review the actual available channels and their definitions: commanded torque, engine response, clutch speed and pressure do not all measure the same thing. The absence of throttle closure by itself does not establish that engine torque was unchanged.
Shift complaints and follow-ups
A modified Audi 4.0T AMAX shift discussion reports a 2–3 over-rev or failed shift. An earlier related report describes improved drivability following torque-model edits without resolving the shift problem. A participant suggests a TCU limitation, but the later follow-up does not demonstrate a fix. These posts do not establish a numerical torque limit or a portable map change.
In a separate Macan hesitation case, the owner suspects slip and a respondent interprets a log differently. The underlying attachment was not independently reviewed and no confirmed resolution is established. Hesitation or a difference between two differently defined torque values is not sufficient proof of clutch slip.
A cold 2–1 oscillation discussion includes other owners' mechatronic repair experiences; the original poster distinguishes the symptoms and does not establish a final cause. Treat hydraulic, mechanical, adaptation and temperature effects as possibilities to diagnose, not interchangeable fixes.
Build a matched record
- Record gearbox and TCU identifiers, modifications, fault memory, fluid service and relevant adaptations using the service procedure for the exact car.
- Capture shift request and phase, commanded and actual gears, engine speed and torque signals, defined clutch/input speeds, applicable pressures, pedal, throttle, ignition and temperatures. Time-align engine and transmission logs where possible.
- Compare the affected shift against a repeatable baseline at similar operating conditions. Check sensor definitions and logging rate before interpreting a brief transient; compare commanded and observed behaviour rather than assuming either proves physical slip.
- Investigate faults and mechanical or hydraulic condition alongside calibration. Do not copy pressure values or disable protections on the strength of a forum report.
The forum cases are owner reports, not independently verified repairs. Consult current Audi service information for the fitted variant. See also DQ500 shift selection; the 0B5 is a separate gearbox. Sources reviewed 17 November 2026.