Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Tuning
Parent
Bosch EDC16
Applies to
Bosch EDC16, Bosch EDC16CP34, Bosch EDC16CP34 CRAFTER, Bosch EDC16U1, Bosch EDC16U31, Bosch EDC16U34
Tool groups
None
Manufacturers
Audi, SEAT, Škoda, Volkswagen

Scope

Use this guide before selecting an EDC16 definition or comparing tunes. Engine code, injection hardware, ECU hardware/software, transmission and market equipment all matter. The examples below identify historical installations; they do not establish interchangeable files or a complete fitment list.

Engine examples: preserve the manufacturer's level of identification

Documented engine/applicationInjection and controller evidenceApplicability detail
BKD, 2.0 TDI 103 kW, four valves per cylinderSolenoid unit injectors; EDC16. VW SSP 316, printed pages 5 and 17–19.The illustrated EU4 specification lists EGR and an oxidation catalyst. The document does not specify U1, U31 or U34 in its technical-data table.
BXE / BLS, 1.9 TDI 77 kW, Golf Variant 2007Solenoid unit injectors; Bosch EDC16. VW SSP 400, printed page 41.In this example BXE is the version without a DPF; BLS has a DPF. Do not infer the equipment of another market or modified vehicle from displacement.
BMP, Passat 2006 2.0 TDI 103 kW, two valves per cylinderBosch EDC16. VW SSP 339, printed page 32.The documented engine has a DPF; it is a different installation from the four-valve BKP below.
BKP, Passat 2006 2.0 TDI 103 kW, four valves per cylinderPiezo unit injectors; Simos PPD 1. VW SSP 339, printed pages 33–34.This is outside Bosch EDC16. A 2.0 TDI or PD badge and the same rated output do not identify the controller.
BMK Phaeton / BKS Touareg, 3.0 V6 TDIPiezo common rail; Bosch EDC 16 C. VW SSP 350, printed pages 4–5.The document uses the broad C designation. It does not resolve every vehicle to an exact CP suffix or software version.
BJJ / BJK / BJL / BJM, Crafter 2.5 TDIPiezo common rail; Bosch EDC 16 C. VW SSP 371, printed pages 4–8, French edition.The reference distinguishes EU4/EURO 4 filter-equipped versions and EU3/EURO 3 offerings without a DPF. Check market and homologation as well as engine code.

AutoTuner's EDC16/PPD coverage announcement separately lists selected VAG unit-injector applications under EDC16U1, U31 and U34, and selected 2.5/2.7/3.0 TDI applications under CP34. Its list is evidence of that supplier's coverage, not a rule assigning one suffix to every engine code above. Confirm the installed controller and current protocol instructions. The Crafter hub documents more specific CP34 tool-list examples; later EDC17 applications require their own identification.

Record enough identity to make a comparison repeatable

  • Vehicle/VIN, model year, engine code, market, emissions equipment and changes to injectors, turbocharger or transmission.
  • Bosch and OEM part numbers, hardware identification, complete software/calibration identifiers and ECU coding. Record gearbox code and TCU identification where fitted.
  • Original read provenance, programmer/protocol, read scope, file length and a file hash. A label, matching file size or a successfully imported map pack does not establish a software match.

EVC warns that a Damos/A2L file may not match the binary and that a single offset may not import all maps. Treat a partial import as work to verify, rather than evidence that the remaining addresses are correct. EVC: finding a Damos/A2L offset.

DSG torque figures: establish what the number describes

Volkswagen's early 02E training specification gives a maximum of 350 Nm, depending on engine. It describes torque entering through the dual-mass flywheel and explains that current engine torque is a basis for clutch-pressure calculation. These are properties of the documented gearbox and control system. VW SSP 308, printed pages 5, 13 and 51.

Calibration implication: this specification does not identify a universal 350 Nm software limiter, establish a higher safe tuned limit, or convert wheel torque into engine torque. A pedal request, an ECU limit, calculated torque and measured output need separate labels. Under-reporting engine torque to obtain more fuel can undermine the consistency of engine/gearbox coordination; investigate the actual torque model and TCU request instead.

Reported discussion: the 2014 NefMoto thread EDC16 BKD 03G906016HM Questions concerns a Seat Altea BKD DSG and compares stock output with larger map values. It asks whether a fixed percentage should be added. The thread does not verify such a conversion or a safe DSG limit. Do not turn those questions into a tuning formula.

BEW gearbox-swap cruise-control case

Reported case, September 2013: a contributor described loss of cruise control in sixth after fitting a six-speed gearbox to a BEW installation with a reported 2005 Jetta five-speed donor. The files named were 038906016Q and tuned 038997016L. A reply reported success after comparing a matching six-speed calibration and changing the gear-dependent cruise-inhibit codeword named CWFGRGA_1_A. NefMoto: EDC16 BEW, no cruise control in sixth.

Diagnostic use: add gear-dependent cruise permission to the checks after a gearbox conversion. First verify road-speed/engine-speed plausibility, recognised gear where available, brake/clutch inputs, cruise status, coding and faults. Validate the symbol, bits and selection logic for the exact software before editing; the reported remedy does not justify copying a byte value or cross-flashing a donor file. The forum report has not been independently reproduced by this wiki.

Continue with PD injection duration and timing and logging and torque diagnosis.

Evidence and review status

Reviewed 16 November 2026. VW self-study programmes are manufacturer training material, linked through independent mirrors; they describe their original applications and are not current workshop instructions. Tool coverage is supplier-specific. NefMoto cases were reviewed from publicly indexed text; direct thread retrieval was blocked during this review, and attachments/binaries were not validated. Practical implications above are editorial reasoning, not OEM-approved tuning values.