Scope and identification
This example covers the EA855 EVO 2.5-litre five-cylinder in Audi’s DAZA TT RS training material and the associated MED17.1.62 tuning context. Audi SSP 920273 spells the controller designation “MED 17.01.62”; EcuTek identifies MED17.1.62 for its stated 2017–2020 RS3 and TT RS applications. Identify the engine, ECU part number, software and market before using a definition or assuming another 2.5 TFSI has the same system. Audi SSP 920273, pp. 1–3 and 46–51; EcuTek EA855 tuning guide.
Two injection paths, several operating modes
The documented engine has a low-pressure rail supplying intake-manifold injectors and a high-pressure rail supplying direct injectors. Audi describes the FSI system as designed for up to 250 bar and the MPI system as rated at 7 bar; these are system ratings, not target pressures for a tune. It identifies sensors for both fuel-pressure circuits. Establish the pressure reference, units and actual operation before interpreting a log.
Both sets of injectors do not necessarily deliver fuel at every operating point. Audi lists single- and dual-phase high-pressure injection as well as combined MPI/FSI operation, with starting examples that use FSI. Record the active mode and, where available, the commanded split before attributing a mixture error to either circuit. Hardware, injector characteristics and calibration details can vary by application. Audi SSP 920273, pp. 46–49.
Trace the request and observe the result
EcuTek describes a torque-based request path in its EA855 example: driver demand and limits feed a cylinder-fill request, which is converted through the air and pressure model. Its guide distinguishes slower air-path responses from faster torque actions such as ignition and fuel control. Map selection can depend on operating mode, flap, valve-lift or cam state. Confirm the active calibration and conditions before comparing target and actual values. EcuTek EA855 tuning guide.
Build a baseline with the available request and measured signals: lambda, fuel pressures, load or air charge, manifold and pre-throttle pressures, wastegate request and response, temperatures, ignition and per-cylinder knock correction. Include injection mode or split if the logger exposes them. Record fault and adaptation state, fuel, hardware and conditions. A fuel-trim error alone does not identify which injector circuit or sensor is responsible.
Using MxT as a reference
The MxT MED17 guide discusses dual-injection, torque and log-analysis workflows. The project’s README classifies its MED17 support as beta. Check any suggested maps, formulas and assumptions against the exact ECU definition, Audi’s engine information and independent measurements; the guide’s broad descriptions should not be applied to every MED17. Keep component-protection and diagnostic functions understood when reviewing a change.
MxT workflow context is adapted and rewritten from TracqiTechnology/MxT contributors; Apache License 2.0, full text.
Related pages
Bosch MED17.1.62 · Volkswagen Group EA855 R5 engines · Mixture tuning: AFR and lambda · Engine knock