Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Bosch ME9
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

ME 9.2 is the Bosch controller for the N62. It runs the engine. A separate Valvetronic control module runs intake-valve lift. The two modules sit together in the electronics box with the integrated voltage supply. Programme data, the fault memory and the adaptation values are stored in flash EEPROM. The shell is the 134-pin standard construction, in five connector modules of 9, 24, 52, 40 and 9 pins, built to the BMW specification for this system. A fan in the floor of the electronics box, driven by this controller, pulls air from the passenger compartment.

The work it is given

Air is Valvetronic, the electronic throttle, the hot-film meter and the variable intake. Fuel is the supply and the injectors. Ignition is direct, with knock control and ignition monitoring. Emissions are secondary air, an oxygen sensor before and after the catalyst on each bank, sensor heating, misfire detection, evaporative purge and leak testing, and the malfunction indicator. Performance control is bi-VANOS, oil condition, the electric cooling fan, the alternator, the electronics-box fan, comfort start and cruise control. The functions that had not changed from the previous Bosch systems are not repeated as new work.

Sensors and outputs that match a V8

Four knock sensors, two intake camshaft sensors and two exhaust camshaft sensors follow the two banks. So do two pre-catalyst and two post-catalyst oxygen sensors, and a VANOS solenoid for each cam on each bank. There is a crankshaft sensor, a pedal module, a manifold pressure sensor, a variable-intake position sensor, an oil-condition sensor, coolant temperature at the outlet and a water-temperature sensor, and a barometric sensor inside the controller. Outputs include the eight injectors, eight ignition coils, the throttle, the intake actuator, the secondary-air pump, the purge valve, the mapped thermostat, both fans, and the Valvetronic module.

The N73 V12 does not use this unit. Its sheet names two MED 9.2.1 controllers. The wider petrol story is on BMW petrol engine management, and the engine is on N62.

Identification photograph

The seller identifies this BMW example as ME9.2; the label shows Bosch 0 261 209 020 and DME 7 542 300. This is one example; confirm the complete part and software identification.

ECU example identified as ME9.2
Example identified as ME9.2. Photograph: eBay seller vietnam-vet-and-sons-1967; reproduced with permission.