Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Tuning
Parent
Section level
Applies to
Bosch MD1CS003
Tool groups
None
Manufacturers
None

Boot glitching is a form of fault injection used by some specialist programmers to gain access to a supported electronic control unit (ECU). In a voltage-fault procedure, a carefully timed electrical disturbance is applied during a sensitive stage of the processor's start-up. This can allow the tool to perform an authorised access or software-patching procedure that ordinary service-mode communication cannot complete.

Boot mode is a connection or start-up mode; it does not automatically mean glitching. Likewise, an ECU listed for bench programming is not necessarily supported while its tuning protection is active. The precise access sequence, backup and recovery options depend on the particular ECU, software and programmer.

Typical workshop workflow

  1. Identify the vehicle, complete ECU part numbers, software version and current lock status; select the exact supported protocol in the programmer.
  2. For a supported locked unit, the manufacturer's boot-unlock procedure may require opening the case, access to the circuit board, an adapter and, for some voltage methods, removal or handling of a small component. Follow the current tool-specific instructions.
  3. Once the tool reports that its unlock or patch has succeeded, the relevant protocol may allow a backup and reading or writing in boot or through the ECU connector in bench mode. Verify the available operations for the exact ECU and configuration.

Opening, soldering and incorrect electrical contact can damage a board or microcontroller. Make a suitable backup when the tool allows, provide stable power and plan recovery and resealing before starting. An unlock is an access procedure; it is not itself a calibration change.

Examples for Bosch MD1CS003

  • Magicmotorsport Flex lists a local Boot Glitch then Bench procedure for the Stellantis MD1CS003 TC298. Its later Korhex announcement contrasts the existing voltage-fault procedure with its electromagnetic alternative. See Magicmotorsport's MDG1 release and MD1CS003 release.
  • Alientech KESS3 lists MD1CS003 among the ECUs supported by its separate KESS3 Unlock Module in Boot, followed by Boot or Bench access, subject to licence and software. Alientech calls this a Boot Unlock and patch; consult its actual connection instructions for the physical method. Alientech 3.50; Alientech 3.51.
  • Microtronik's HEXPROG II 1.0.125 announcement lists voltage fault injection (VFI) for locked MD1CS003 TC298. It distinguishes HEXPROG II from the earlier HEXPROG, which it says does not support this unlock.

Electromagnetic fault injection (EMFI) is another way of creating the brief disturbance, using a positioned pulse probe rather than an electrical voltage-glitch connection. It may still require access to the opened ECU; see ECU electromagnetic fault injection (EMFI). Coverage and physical requirements change with tool updates.

For vehicle applications, part-number examples and the different security states, see Bosch MD1CS003. This page describes the method; it is not a pinout or a substitute for the current instructions.