Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Tuning Tools
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
Diagnostic tools
Manufacturers
EVC
Two views of the EVC UCM100 OBD-II module
EVC UCM100. Image credit: EVC electronic. Image source.

← EVC electronic

UCM100 is EVC’s OBD-II interface for standard diagnostic data, not a programmer. EVC says it reads SAE J1979 services over K-line or CAN: current data, stored and current faults, clearing the fault memory, and vehicle information such as the calibration verification number. The Windows program is WinUCM.

Selected live values can be saved to a log. WinOLS can open that log, or read the UCM100 directly, and show the values as a moving crosshair on a map. EVC’s access-indicator table says this shows measured values rather than the processor’s accesses to a map. Assigning those values to map axes is a manual PID assignment. The interface can be used at the vehicle without WinOLS running.

Sources