Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
MBE Systems standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

The MBE 941 is an older serial ECU; MBE’s serial interface document identifies its main connector and communications signals. It does not establish all engine-control pins for every hardware variant. Source and identification.

Wiring and pinout

Model wiring documentation: MBE serial interface protocol: 941 mapping communications, not a complete application pinout. Check connector view, wiring harness, ECU part number and installed calibration before connecting power. Programmable input and output functions depend on the map and software.

Configuration and support

For programmable SBD-supplied ECUs, Easimap is used to inspect and change maps, subject to the interface and access of the actual ECU. Some vehicle-manufacturer supplied units are locked; SBD’s FAQ warns against attempting downloads to locked ECUs. Do not assume that a serial ECU map or harness transfers directly to a newer CAN unit.

Evidence limits

Verify the build, trigger inputs, coil-driver type and software with the supplier. Not all historic variants and pin assignments are documented here.

Manufacturer serial and mapping connections

MBE Systems' 941 serial-interface document, page 2, identifies these communications and trim positions on the 55-way main connector and mapping interfaces. This is a partial schedule, not the full engine connector. The document identifies Byte Mode and Broadcast Mode as different trim-input configurations.

941AA35x communication and mapping

Signal55-way ECU pin9-way ECU / standard harness pinPC DB9 pin
ECU transmit4522
ECU receive4633
Fuel trim476—
Ignition trim107—
Ground715

Throttle potentiometer connections

SBD’s serial-ECU throttle-pot guide gives the following connections for its 941/970 applications. This is a partial schedule for that documented harness, not a complete model pinout. Confirm the ECU variant and wiring at the unit.

ECU pinThrottle sensor connection
12Electronic ground / sensor return
305 V throttle reference
35Throttle signal

Structured pinout

The documented positions of the 55-way main connector and the 9-pin mapping connector are listed as a structured pin index in MBE 941 connector pinout.