The MBE 912 is an early engine-management controller. A 1993 period article hosted by SBD describes a 912 controlling injection and distributorless ignition in one engine installation. This example does not establish the capabilities of every 912 hardware variant.
Identification and software
Record the full label, hardware and firmware revision, vehicle installation and existing calibration before changing the unit. Ask MBE or SBD for the correct documentation and supported interface; the mapping software and cable used on newer CAN units should not be assumed compatible. MBE software and connection guidance.
Throttle potentiometer connections — partial
SBD’s throttle-pot wiring guide explicitly lists these connections for its 956/912 application. It is a partial connector schedule: it does not establish all 912 revisions or the complete main connector. Confirm the original harness and hardware before connecting.
| ECU pin | Throttle sensor connection |
|---|---|
| 1 | Electronics ground / sensor return |
| 5 | 5 V throttle reference |
| 15 | Throttle signal |
See the MBE Systems model index for other separately documented controllers.
912-C main ECU connector
The following 15 positions are from the SBD MBE912 pinout sheet, headed 912-C and dated January 2014. Confirm the exact ECU suffix and installation before applying the table to another 912 version. The sheet’s second page includes Ford and GM crank sensor wiring, including the GM screen on ECU pin 4; use that diagram for the sensor and harness being installed.
| ECU pin | Signal |
|---|---|
| 1 | Electronics ground |
| 2 | ECU supply +12 V |
| 3 | Ignition drive 1 |
| 4 | Power ground 2 (braid) |
| 5 | Throttle reference (5 V out) |
| 6 | Speed signal |
| 7 | Air temperature signal |
| 8 | Coolant temperature signal |
| 9 | Power ground 1 (braid) |
| 10 | Ignition drive 2 |
| 11 | Injector drive |
| 12 | Speed return |
| 13 | Tacho signal |
| 14 | Fuel pump relay or gearshift light |
| 15 | Throttle signal |
912/956 wiring harness interface
SBD’s separate 912–956 series wiring instructions identify a four-way Sure Seal harness interface; these are interface positions, not the numbered main ECU connector above. Pins 1 and 2 receive battery positive through a relay as shown in the SBD diagram. Identify the interface and harness before making connections.
| Interface pin | Harness colour | Function in SBD harness |
|---|---|---|
| 1 | Purple | Battery positive via relay |
| 2 | White | Battery positive via relay |
| 3 | Grey | Gearshift light earth trigger |
| 4 | Green | Rev counter |
Structured pinout
The 912-C main connector and the four-way harness interface are redrawn as a structured pinout in MBE 912 connector pinout.