Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Autronic standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None
Autronic sm2 ECU
Autronic sm2 manufacturer product image: Autronic; reproduced with permission.

Autronic SM2 is a standalone or earlier programmable engine-management system. SM2 lists eight selectable peak-and-hold injector drivers and four ignition outputs; standard ignition does not have dwell control. It has separate J1/J2/J3 connector arrangements and RS232 communication. Model-specific information.

Identification and features

Record the ECU label, model, part number, hardware revision, firmware, configured injectors, ignition hardware and loom before comparing systems. Some outputs can be reassigned; hardware, software, current limits and engine-specific options determine what is actually available.

Processor

Autronic's product page (manufacturer documentation) gives the SM2 microcontroller as a 16-bit Intel part running at 16 MHz. The exact part number is not stated in the sources checked.

Engine applications

The SM2 is a universal unit rather than a vehicle-specific ECU. Per Autronic it suits port-injected spark-ignition engines without drive-by-wire throttle or feedback-controlled variable camshafts, including high-output supercharged or turbocharged engines, two-rotor rotary and two-stroke engines, and engines with uneven firing intervals such as two- and four-cylinder V motorcycle engines and V6 car engines. Selectable cylinder counts are 1 to 8, 10, 12, 14 and 16, with full sequential injection up to eight cylinders and semi-sequential operation above that. Autronic positions it for high-performance motorsport. No specific engine codes are listed by the manufacturer.

Hardware per Autronic: supply 6.2 to 23 V, eight injector drivers selectable 4 A/1 A or 2 A/0.5 A peak/hold, four 1 A open-collector ignition outputs, four on-off outputs, two high-side PWM outputs, RS232 serial, and a 52-way AMP connector made up of 10-way, 18-way and 24-way plugs.

Wiring and pinout

Consult the Autronic SM2 wiring and documentation source and identify the exact connector face, part and version. Do not apply wiring from a similarly named model. If an exact drawing is unavailable for the unit at hand, obtain it from the manufacturer or supplier before making connections.

SM2 standard loom connector assignments

Autronic's SM2 basic wiring, traction-control option, drawing SM2WR105 revision 001 identifies positions 1 to 10 as J1, 11 to 28 as J2 and 29 to 52 as J3. The complete function table for all 52 positions, previously transcribed on this page, is now on the Autronic SM2 connector pinout page with redrawn pin-index diagrams. Positions 21, 23, 42 and 43 are not labelled in the drawing, which does not declare them safe to use. J4 is the serial connection: RxD, TxD and ground are shown but physical pin numbers are not supplied. Diagram redrawn by Tuning Wiki from the Autronic drawing.

Further information

Sources