
AEM Infinity 508 (manufacturer part 30-7108 / 30-7112) is a programmable Infinity engine-management ECU, a separately identified model in AEM's hardware comparison.
Identification and capability
| Manufacturer specification | Infinity 508 |
|---|---|
| Maximum cylinders, as listed | 8 |
| Sequential injector outputs | 8 high-impedance |
| Ignition | 8 logic-level |
| Connector positions | 80 |
| Electronic throttle | Single |
| CAN channels | 2 |
| Internal wideband channels | 1 |
Compare injector impedance and ignition driver type before connecting components. Maximum cylinder count does not imply every feature or configuration is available simultaneously; verify exact part number, harness and calibration. AEM lists InfinityTuner software separately from Series 1/2 EMS software.
Processor
AEM and Holley marketing text describes the Infinity family as built around a 32-bit, 200 MHz automotive processor rated at 400 MIPS, running a real-time operating system, with a separate power-management processor behind the permanent battery power input (pin C1-10). These are vendor claims; the silicon vendor and part number are not named in AEM's hardware specification or in the trade-press and retailer pages checked, so the MCU family is not established.
Engine applications
The Infinity 508 is a universal standalone ECU for engines of up to eight cylinders rather than a unit tied to one engine. AEM's Series 5 hardware specification includes example system schematics for a 1995 BMW E36 M3, Mitsubishi Lancer Evolution VIII and IX, and a 1993-1998 Toyota Supra 2JZ-GTE, and application-specific plug-and-play harnesses exist, such as the Nissan SR20DET harness described below. Manufacturer documentation; engine codes beyond those named are not given.
Connector and wiring
AEM's Infinity 508 family hardware and wiring reference gives electrical limits and connector diagrams. Match the ECU's number and physical harness, and verify connector orientation. The 506 and 508 share an 80-way shell but some pin assignments differ; Series 3 and Series 7 use different connectors and are not interchangeable by name.
Example connector differences
For the specific Nissan SR20DET PNP harness documented by AEM, C1-3 and C1-4 are injector outputs 7 and 8; C1-10 is permanent battery power and C1-11 through C1-14 are ignition coil signals 4, 3, 2, 1. The source says C1-10 must be powered before ignition is switched on and that the coil signals cannot drive a coil primary directly. These are ECU connector functions in the 30-3517 application-specific wiring guide, not a universal factory vehicle pinout.
Connector pinout
The full 80-pin C1 assignment (manufacturer documentation) is on the AEM Infinity 508 connector pinout page. On the 508, pins 3 and 4 carry injector 7 and 8 and pins 31 and 32 carry coil 7 and 8. The source gives no connector face view, so the diagram is a numbered pin index. Diagram redrawn by Tuning Wiki from the AEM Series 5 hardware specification.
Further documents
- Manufacturer wiring and hardware specifications
- AEM Infinity user manual and comparison
- AEM engine management support and application harnesses
- AEM manufacturer index
Sources reviewed 17 November 2026. Availability of an exact part or application should be checked separately.
AEM formerly called 30-7108 the Infinity-8h. AEM model-name change announcement.
Sources
- Infinity Hardware Specification 30-7106/7108/7112. AEM manufacturer document, build 20 January 2021. Accessed 19 November 2026.
- AEM Performance Electronics Infinity Series 7 ECU. Trade press repeating AEM's processor description. Accessed 19 November 2026.