Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Engines
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
Maserati

This page covers the late Biturbo-family engines: the four-cam 24-valve V6 used from 1988 and the 32-valve Shamal V8. Sources are a buyer's guide from a UK Italian-car magazine, factory-literature text and engine-history pages on an enthusiast site, so figures are as published and some are marketing numbers.

Four-cam 24-valve V6

  • Produced 1988–1998, it added four-valve heads to the 90° Biturbo V6, with new turbochargers and Weber-Marelli injection. The 2.0 litre appeared in the Racing (1990–91, 285 bhp), Barchetta (1991, 315 bhp) and Ghibli II (1992, 306 bhp). The Ghibli Cup (1995–96) had redesigned heads and roller-bearing turbochargers, rated 330 bhp.
  • Export Ghibli cars used a 2.8 litre version rated 284 bhp at 6,000 rpm and about 42 kgm (413 N·m) of torque at 3,500 rpm.
  • Output figures by year (2.0 litre): 285 bhp at 6,500 rpm (Racing), 315 bhp at 6,250 rpm (Barchetta), 306 bhp at 6,250 rpm (Ghibli II) and 330 bhp at 7,000 rpm (Cup).

Engine management on the Ghibli

  • The Ghibli's engine management was new: direct (distributorless) ignition and a separate ignition and fuel ECU for each bank of three cylinders. The two units work independently, so a fault on one bank can leave the engine running on the other.
  • Reported weak points are glitches and corrosion in fuses and relays; lambda sensors are the most commonly replaced sensor, largely because they are exposed to damage on a low car.
  • One chipped import is reported to have broken a connecting rod, which is a caution against uncontrolled remaps.

Cam drive: belt and chains

  • On the four-cam V6 the toothed belt at the front of the engine drives only the exhaust camshafts. The inlet camshafts are driven by chains looped over from the exhaust cams at the back of the engine.
  • Major service comes every 24,000 miles and includes the belt. The chains must be replaced at about 48,000 miles, which can only be done properly with the engine removed; the book time was 30 hours.
  • Service interval for all Ghiblis was 6,000 miles or one year, with a different schedule at each service up to 96,000 miles.
  • One car is reported to have snapped a timing chain at 13,000 miles without bending a valve.

Reported faults (Ghibli)

  • Both the 2.0 and 2.8 are reported as reliable if maintained. Individual failures include a seized roller-bearing turbo on a Cup car at 25,000 miles (replacement was quoted at about £3,900 each in 2000) and a block cracked by a car run with the wrong thermostat.
  • Original radiators leak and most cars need a replacement; the low-mounted alternator collects road debris and salt.
  • Electronic Koni dampers fail by leaking or by seized motors and are costly to replace.
  • Discs corrode because no brake backplates were fitted; ground clearance is low on 16 inch cars.
  • Many Ghiblis have no spare wheel because the oil-cooled differential occupies the space; tyre foam was supplied instead.

Ghibli running changes

YearChange
1992–94Original Ghibli: 2.0 (Italy) with six-speed gearbox, 2.8 (export) with ZF five-speed (standard pattern); 16 inch wheels; Koni electronic dampers; Torsen-type differential with oil cooler as described by this source (other pages call the differential a Ranger).
1995Bosch ABS and 17 inch wheels (Ghibli ABS in the UK).
1995–96Ghibli GT: Quattroporte axle (taken from the Ferrari 456), tubular rear suspension from the race cars, Getrag six-speed; black headlamp backing distinguishes it.
1996–98Open Cup replica: 2.0 only, roller-bearing turbos, modified engine mapping, freer exhaust, 330 bhp, larger Brembo brakes. A further 250 Ghiblis were built in early 1999 from remaining parts.

Shamal V8 engine (AM 479)

  • All-aluminium 90° V8, 80 mm × 80 mm, four overhead camshafts, four valves per cylinder, with a compact design and a "monolithic" crankshaft support cast as one piece.
  • The angle between inlet and exhaust valves was reduced to 20° and combustion chambers were made very compact for efficient combustion.
  • Factory literature rates it at about 325 bhp at 6,000 rpm and 320 lb-ft at 2,800 rpm, with Weber-Marelli injection and ignition and electronic knock protection: a system reading vibration continuously and adjusting ignition advance and boost.
  • The engine is designed to be removed from the front: with the bumper off, the subframe carrying the intercoolers and radiator is removed and the power unit slides forward.
  • Later V8s changed the crankshaft; diff problems, leaking radiators, non-charging alternators and a cam belt of unknown age are the usual checks.

Tuning conversions reported

A German specialist's conversions for the Ghibli are described as follows. They are sold by that firm and the figures are the firm's own claims, not independently measured.

  • 2.0 litre: 360 hp and 440 hp options. The 440 hp version is quoted at 8,200 rpm with a fuel cut at 8,500 rpm in a modified EPROM, balanced crank, rods and pistons, larger valves, enlarged and polished ports, changed valve timing, about 50 mm intake pipes, larger roller-bearing IHI turbochargers of the type used on the 3200 GT, Indy-style dump valves venting into the engine bay, larger oil cooler and intercoolers, and a freer-flowing stainless exhaust. Peak torque is quoted at 408 N·m at 6,400 rpm against 279 N·m for the standard 306 hp car.
  • 2.8 litre: 355, 408 and 440 hp options; a 3.1 litre version at 475 hp; and a 3.2 V8 conversion at 450 hp.
  • Supporting parts: a clutch for about 640 N·m, 20 mm lowering springs and harder suspension bushes.

The unbuilt 36-valve engine

A 1,996 cc four-cam V6 with six valves per cylinder (the "6:36" or "Hi-Tech" engine) was announced on 14 December 1985 but never reached production. Factory literature claimed 261 bhp at 7,200 rpm on only 0.8 bar boost, water-cooled twin turbochargers, a centrally placed spark plug, belt-driven overhead cams and a patented finger-follower valve adjustment.

References

Related: Shamal, Ghibli II, Quattroporte IV, Karif and Barchetta, Maserati Biturbo hub.