Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Modded Cars
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
Ford

Changes from revision 2 to revision 2

Removed text is struck through; added text is highlighted.

This is Ford Focus RS Mk1 No. 1685, stripped to a bare shell for a weld-in cage after four years with its owner. Bob Dowen Rally Prep carried out the cage and shell work. The interior strip included removing the dashboard and heater and the sound deadening.

Dashboard removed during the strip-down of No. 1685. lukefrs on PassionFord, reproduced with permission. Original photo post.

Strip-down

The dashboard and heater were removed and the sound deadening stripped, leaving a bare shell.

Cage and shell work

The work includes fabricated cage gussets, sill stands and stitch welding around the rear strut tops, engine bay and engine mounts.

Sill-stand tube in the shell during fabrication. lukefrs on PassionFord, reproduced with permission. Original photo post.

Driving position

The seat and a Tilton 600-series pedal box were trial-fitted so the driving position could be set while the shell was bare.

Sources

PassionFord build thread: No. 1685 introduction and interior strip-downPassionFord build thread: cage gussets and fabricationPassionFord build thread: pedal-box trial fit and stripped shellPassionFord build thread: sill stands, stitch welding and seating position

Rendered revisions

Open each version to inspect formatting, tables and photographs.

Revision 2: Luke’s Ford Focus RS Mk1 No. 1685 shell build

This is Ford Focus RS Mk1 No. 1685, stripped to a bare shell for a weld-in cage after four years with its owner. Bob Dowen Rally Prep carried out the cage and shell work. The interior strip included removing the dashboard and heater and the sound deadening.

Dashboard removed during the strip-down of No. 1685

Dashboard removed during the strip-down of No. 1685. lukefrs on PassionFord, reproduced with permission. Original photo post.

Strip-down

The dashboard and heater were removed and the sound deadening stripped, leaving a bare shell.

Cage and shell work

The work includes fabricated cage gussets, sill stands and stitch welding around the rear strut tops, engine bay and engine mounts.

Sill-stand tube in the shell during fabrication

Sill-stand tube in the shell during fabrication. lukefrs on PassionFord, reproduced with permission. Original photo post.

Driving position

The seat and a Tilton 600-series pedal box were trial-fitted so the driving position could be set while the shell was bare.

Sources

Revision 2: Luke’s Ford Focus RS Mk1 No. 1685 shell build

This is Ford Focus RS Mk1 No. 1685, stripped to a bare shell for a weld-in cage after four years with its owner. Bob Dowen Rally Prep carried out the cage and shell work. The interior strip included removing the dashboard and heater and the sound deadening.

Dashboard removed during the strip-down of No. 1685

Dashboard removed during the strip-down of No. 1685. lukefrs on PassionFord, reproduced with permission. Original photo post.

Strip-down

The dashboard and heater were removed and the sound deadening stripped, leaving a bare shell.

Cage and shell work

The work includes fabricated cage gussets, sill stands and stitch welding around the rear strut tops, engine bay and engine mounts.

Sill-stand tube in the shell during fabrication

Sill-stand tube in the shell during fabrication. lukefrs on PassionFord, reproduced with permission. Original photo post.

Driving position

The seat and a Tilton 600-series pedal box were trial-fitted so the driving position could be set while the shell was bare.

Sources