Page organisation in this revision
- Page type
- Technical article
- Subject
- Modded Cars
- Parent
- Section level
- Applies to
- No ECU-specific applicability
- Tool groups
- None
- Manufacturers
- Alfa Romeo
Changes from revision 2 to revision 2
Removed text is struck through; added text is highlighted.
TheStig's Alfa Romeo MiTo is a 135 CV 1.4 MultiAir Distinctive, bought new in October 2009 by its owner Alessio, and converted with a Garrett 1446 turbo. Seven years later it gained 305 mm Brembo brakes, a reinforced clutch and a direct intake. The owner reports a dyno result of about 200 CV and just over 300 Nm (owner-reported, single source).
Turbo and chassis
The first build list paired a Garrett 1446 turbo with a larger Orra Racing intercooler, a Brain 200-cell catalyst in the downpipe, a Ragazzon rear exhaust section and Serial Tuning engine calibration. The chassis ran Eibach springs, 12 mm spacers front and rear, and drilled Zimmermann front discs.
Seven-year update
Brakes were upgraded to 305 mm discs with four-piston Brembo calipers, braided lines and Roesch XC4 pads. A reinforced Fiorentini clutch was fitted and the panel filter was replaced with an MTD direct intake. The owner-reported dyno result was about 200 CV and just over 300 Nm.
Photographs by TheStig, reproduced with permission from the ClubAlfa.it posts linked below.
Sources
ClubAlfa.it build thread: original turbo and chassis buildClubAlfa.it build thread: seven-year update with brakes, intake, clutch and dyno figures
Rendered revisions
Open each version to inspect formatting, tables and photographs.
Revision 2: TheStig’s Garrett 1446 Alfa Romeo MiTo 1.4 MultiAir
TheStig's Alfa Romeo MiTo is a 135 CV 1.4 MultiAir Distinctive, bought new in October 2009 by its owner Alessio, and converted with a Garrett 1446 turbo. Seven years later it gained 305 mm Brembo brakes, a reinforced clutch and a direct intake. The owner reports a dyno result of about 200 CV and just over 300 Nm (owner-reported, single source).
Turbo and chassis
The first build list paired a Garrett 1446 turbo with a larger Orra Racing intercooler, a Brain 200-cell catalyst in the downpipe, a Ragazzon rear exhaust section and Serial Tuning engine calibration. The chassis ran Eibach springs, 12 mm spacers front and rear, and drilled Zimmermann front discs.
Seven-year update
Brakes were upgraded to 305 mm discs with four-piston Brembo calipers, braided lines and Roesch XC4 pads. A reinforced Fiorentini clutch was fitted and the panel filter was replaced with an MTD direct intake. The owner-reported dyno result was about 200 CV and just over 300 Nm.


Photographs by TheStig, reproduced with permission from the ClubAlfa.it posts linked below.
Sources
Revision 2: TheStig’s Garrett 1446 Alfa Romeo MiTo 1.4 MultiAir
TheStig's Alfa Romeo MiTo is a 135 CV 1.4 MultiAir Distinctive, bought new in October 2009 by its owner Alessio, and converted with a Garrett 1446 turbo. Seven years later it gained 305 mm Brembo brakes, a reinforced clutch and a direct intake. The owner reports a dyno result of about 200 CV and just over 300 Nm (owner-reported, single source).
Turbo and chassis
The first build list paired a Garrett 1446 turbo with a larger Orra Racing intercooler, a Brain 200-cell catalyst in the downpipe, a Ragazzon rear exhaust section and Serial Tuning engine calibration. The chassis ran Eibach springs, 12 mm spacers front and rear, and drilled Zimmermann front discs.
Seven-year update
Brakes were upgraded to 305 mm discs with four-piston Brembo calipers, braided lines and Roesch XC4 pads. A reinforced Fiorentini clutch was fitted and the panel filter was replaced with an MTD direct intake. The owner-reported dyno result was about 200 CV and just over 300 Nm.


Photographs by TheStig, reproduced with permission from the ClubAlfa.it posts linked below.
Sources