Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Modded Cars
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
BMW, Jeep

Changes from revision 2 to revision 2

Removed text is struck through; added text is highlighted.

This is a 1988 Jeep Comanche pickup rebuilt with a BMW M57N diesel engine driving the Jeep AW4 automatic transmission through an adaptor. The engine was collected in March 2024, trial-fitted and then installed with fabrication and wiring work.

The M57 during trial fitting in March 2024. Photograph by colthrax, reproduced with permission.

Engine and transmission

An adaptor joins the M57 to the Jeep AW4 gearbox. The owner describes a sequential shift arrangement using an Arduino and NiftyShifter, built while working out the throttle signal needed by the automatic transmission controller. Cooling combines the M57 mechanical fan with a Jeep 2.5 diesel radiator and fan shroud.

The later installation, shared in the Comanche Club owner profile. Photograph by colthrax, reproduced with permission.

Browse more M57 4×4 builds and the BMW M57 engine guide.

Sources

Comanche Club build thread: M57 engine swap, trial fit, fabrication and wiring (March 2024)Comanche Club owner profile (May 2024): shift control and cooling

Rendered revisions

Open each version to inspect formatting, tables and photographs.

Revision 2: Colthrax’s M57 Jeep Comanche pickup

This is a 1988 Jeep Comanche pickup rebuilt with a BMW M57N diesel engine driving the Jeep AW4 automatic transmission through an adaptor. The engine was collected in March 2024, trial-fitted and then installed with fabrication and wiring work.

BMW M57 held on lifting straps during trial fit in the Jeep Comanche engine bay

The M57 during trial fitting in March 2024. Photograph by colthrax, reproduced with permission.

Engine and transmission

An adaptor joins the M57 to the Jeep AW4 gearbox. The owner describes a sequential shift arrangement using an Arduino and NiftyShifter, built while working out the throttle signal needed by the automatic transmission controller. Cooling combines the M57 mechanical fan with a Jeep 2.5 diesel radiator and fan shroud.

BMW M57 installed beneath the bonnet of the red Jeep Comanche

The later installation, shared in the Comanche Club owner profile. Photograph by colthrax, reproduced with permission.

Browse more M57 4×4 builds and the BMW M57 engine guide.

Sources

Revision 2: Colthrax’s M57 Jeep Comanche pickup

This is a 1988 Jeep Comanche pickup rebuilt with a BMW M57N diesel engine driving the Jeep AW4 automatic transmission through an adaptor. The engine was collected in March 2024, trial-fitted and then installed with fabrication and wiring work.

BMW M57 held on lifting straps during trial fit in the Jeep Comanche engine bay

The M57 during trial fitting in March 2024. Photograph by colthrax, reproduced with permission.

Engine and transmission

An adaptor joins the M57 to the Jeep AW4 gearbox. The owner describes a sequential shift arrangement using an Arduino and NiftyShifter, built while working out the throttle signal needed by the automatic transmission controller. Cooling combines the M57 mechanical fan with a Jeep 2.5 diesel radiator and fan shroud.

BMW M57 installed beneath the bonnet of the red Jeep Comanche

The later installation, shared in the Comanche Club owner profile. Photograph by colthrax, reproduced with permission.

Browse more M57 4×4 builds and the BMW M57 engine guide.

Sources