SayonaraLicense bought this white GR Yaris in April 2021 and initially used a DTUK Stage 2 module with breathing modifications. A later Litchfield build and mapping session produced approximately 380 bhp and 450 Nm, according to the owner. Owner’s introduction and specification

Engine and calibration
The build used Kelford A-profile camshafts, springs and retainers, an HKS head gasket, Lamspeed H13 head studs and Syvecs management. The owner retained the original turbo for this setup. A Wagner intercooler, charge pipes and turbo elbow complemented an Eventuri intake and C-Tech three-inch exhaust. Engine and intake specification · Camshaft and valvetrain installation photos

Chassis and later updates
Eibach springs and camber bolts, wheel spacers and a fast-road alignment formed part of the chassis setup. The owner later fitted Recaro Profi SPG seats on Cobra bases and listed Powerflex engine and gearbox mounts. Seat installation · Updated equipment list

The owner says SRD Tuning remapped the car in August 2023. The 380 bhp figure belongs to the earlier Litchfield session, whose printout was posted alongside that update. Photos by SayonaraLicense, reproduced with permission. Litchfield printout and mapping chronology · Reason for the later remap