This is a white Toyota GR Yaris, bought in April 2021 and initially run with a DTUK Stage 2 module and breathing modifications. A later Litchfield build and mapping session produced approximately 380 bhp and 450 Nm (owner-reported; a Litchfield printout was posted by the owner).

Engine and calibration
The build uses Kelford A-profile camshafts, springs and retainers, an HKS head gasket, Lamspeed H13 head studs and Syvecs management. The original turbo is retained. A Wagner intercooler, charge pipes and turbo elbow complement an Eventuri intake and C-Tech three-inch exhaust.

The owner says SRD Tuning remapped the car in August 2023. The 380 bhp figure belongs to the earlier Litchfield session, not to the SRD remap.
Chassis and interior
Eibach springs and camber bolts, wheel spacers and a fast-road alignment form part of the chassis setup. Later additions are Recaro Profi SPG seats on Cobra bases, and the owner lists Powerflex engine and gearbox mounts.

Photos by SayonaraLicense, reproduced with permission.
Sources
- GR-Zoo build thread: introduction, engine and intake specification
- GR-Zoo build thread: camshaft and valvetrain installation photos
- GR-Zoo build thread: seat installation
- GR-Zoo build thread: updated equipment list
- GR-Zoo build thread: Litchfield printout and mapping chronology
- GR-Zoo build thread: reason for the later remap