Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Modded Cars
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
BMW, Jeep

Comanche Club member colthrax documented rebuilding a 1988 Jeep Comanche and fitting a BMW M57N diesel. In March 2024 the builder collected the engine and recorded the trial fit, fabrication and wiring in a multi-page diary. Read the engine swap diary.

BMW M57 held on lifting straps during trial fit in the Jeep Comanche engine bay

The M57 during trial fitting in March 2024. Photograph by colthrax, reproduced with permission.

Engine and transmission

The build uses an adaptor between the M57 and Jeep AW4 gearbox. In the May 2024 owner profile, the builder describes a sequential shift arrangement using an Arduino and NiftyShifter while working out the throttle signal needed by the automatic transmission controller. Cooling combines the M57 mechanical fan with a Jeep 2.5 diesel radiator and fan shroud. Read the owner’s build profile.

BMW M57 installed beneath the bonnet of the red Jeep Comanche

The later installation, shared in the Comanche Club owner profile. Photograph by colthrax, reproduced with permission.

Browse more M57 4×4 builds and the BMW M57 engine guide.