This reference examines supercharger air-model labels in the publicly indexed S85L1031_C2_e.a2l definition. The file describes itself as an enriched Simos 8.5 TFSI project with structure L10 and EPK S85L100. Its origin, rights, completeness and match to a particular ECU or binary are unverified. These are descriptions in one definition, not measured values or proof of runtime behaviour.
Base flow and correction labels
The definition describes ip_flow_vol_scha_bas_1[0] as a supercharger basic volume-flow map. Its two inputs reference an estimated charger pressure ratio and a supercharger-speed quantity. It separately describes fac_vol_scha_ad and fac_vol_scha_ad_as as adaptive correction-factor curves for supercharger volume flow, both using an engine-speed input. The matching descriptions do not establish why two curves exist, which one a particular ECU uses, or how the adaptive factors are learned.
Another curve, ip_rfp_av_max_vol_scha_ad, is described as the maximum recirculation-flap position for supercharger volume-flow adaptation, against engine speed. It is a definition label, not proof that a particular adaptation is active or that a logged flap value uses the same reference and direction. Confirm actual channel definitions, units and installed hardware.
Supercharger power consumption
The file describes ip_pow_loss_scha as a supercharger power-consumption map, referencing charger pressure ratio and supercharger speed. Its separate pressure-ratio quantity is not labelled as the estimated ratio used by the base-flow map. The names do not establish whether any logged value is measured, modelled or derived from a physical speed sensor, or how the map contributes to the ECU’s torque estimate.
A request, a volume-flow estimate, an adaptive correction and a power-loss representation are different quantities. In a supported log, compare engine speed, relevant throttle and bypass position, pressure targets and readings, intake temperature and available air or torque estimates under repeatable conditions. Verify sensor locations, absolute versus gauge pressure and channel definitions before interpreting a discrepancy. A matching label is not evidence that increasing or disabling a table is appropriate.
Definition and system context
The Simos 8.5 overview records the file’s self-identification and discusses related community terminology. The separate L10 torque-limit reference examines other labels in the same file. These descriptions are not interchangeable with the separately documented Simos 8.4 log example.
The A2L describes metadata; it does not supply the actual calibration values of a particular vehicle or establish map selection. Check the source and permitted use, identify the actual ECU and binary, then validate conversions, axes, boundaries and control behaviour before using any definition. Similar symbols in another revision do not prove compatible addresses, scaling or operation.
Source and verification scope
Publicly indexed S85L1031_C2_e.a2l, characteristic and measurement descriptions reviewed 17 November 2026. Retrieved file SHA-256: 2ed20a98b9b55d41347a6b125304aa28c52d2cd955a5e760ee049503a5c88f4b. The hash identifies the inspected text; it does not verify authenticity, rights, vehicle fitment or behaviour.