Tuning Wiki
Applies to

Check the hardware and software limits stated in this article.

This reference examines selected exhaust-gas-temperature model labels in a publicly indexed SCQ110_C_OEM.a2l definition. It describes itself as an enriched Audi/VW Simos 19.3 LK3evo project with reference list SCQ110 and EPK VWSCQ110. Its origin, usage rights, completeness, authenticity and match to any ECU or binary are unverified. Labels and axes are research leads, not evidence that a table is active, that any stored values are safe or that the model matches measured exhaust temperature.

Reference conditions in the definition

The definition calls ip_teg_eng_out_bas the basic engine-out exhaust temperature for reference conditions. It describes ip_iga_bas_teg and ip_iga_ref_teg as basic and reference ignition angles for the exhaust gas temperature model, and ip_lamb_bas_teg as a basic lambda for model calibration across engine operating points. All four maps name n_teg as one axis input; the corresponding measurement is described as a mean engine-speed value for the temperature model. Their other axis input is explicitly NO_INPUT_QUANTITY, although the referenced axis-point name contains maf. The axis-point name alone does not identify its runtime input or prove a physical airflow measurement.

The three ignition and lambda entries are labelled as model reference data. They are not, on that description alone, the final commanded ignition angle or lambda target. The file does not establish the equations, selection logic or calibration values. Confirm definitions and their relationships against the exact software before making any edit.

Corrections and warm-up

The file describes ip_fac_teg_add_iga and ip_fac_teg_add_lamb as factors for additive engine-out-temperature corrections associated with ignition and lambda respectively. Each names n_teg and NO_INPUT_QUANTITY as axis inputs. It separately describes ip_fac_teg_tco as a multiplicative warm-up correction related to coolant temperature; its inputs are tco and tco_st, with the latter described as coolant temperature at start. These labels do not establish the order of operations, magnitude, thresholds or whether the correction is selected in a particular run.

Interpreting logs

COBB's Mk8 engine monitor list distinguishes named modelled exhaust-temperature channels from an exhaust-temperature-sensor raw channel in its pre-CCF set. It does not establish their correspondence to SCQ110, the fitted sensors on a particular vehicle, or the formula behind any channel. Confirm the ECU, logger and monitor set; check whether a channel is measured, modelled, requested or filtered and confirm its location and units. Similar names across tools need not describe the same quantity.

For comparable runs, record starting and operating temperatures, fuel, load, engine speed, requested and actual lambda, ignition, relevant fault codes and available measured and modelled temperatures. Differences between runs can suggest where to investigate, but a model value alone cannot establish an actual component temperature or prove that a thermal protection is active. Use vehicle-specific diagnostic procedures and preserve component protections.

For separately documented SCQ110 turbo protection labels, see Simos 19.3 SCQ110 turbo-speed protection definition reference. The Simos 19.6 thermal logging guide is a separate application and tool example, not confirmation of SCQ110 compatibility.

Sources and verification scope

Publicly indexed SCQ110_C_OEM.a2l, characteristic and measurement descriptions, reviewed 17 November 2026. The inspected text was 60,057,673 bytes, SHA-256 6473bf25107af882ebb3eea6cb0d57c223b2d005451df031ab546bfd1487f45e. The hash identifies the examined file; it does not authenticate it or prove compatibility, rights or behaviour.

COBB Engine Monitor List MK8 Vehicles. Product-specific monitor examples; available channels vary by monitor set and software. Accessed 17 November 2026.