Tuning Wiki
Applies to

Check the hardware and software limits stated in this article.

This reference describes turbocharger-protection labels in a publicly indexed SCQ110_C_OEM.a2l definition. The file describes itself as an enriched Audi/VW Simos 19.3 LK3evo project with reference list SCQ110 and EPK VWSCQ110. Its origin, usage rights, completeness and match to a particular ECU or binary are unverified. Descriptions and axis references do not establish calibration values, actual map selection or runtime behaviour.

Turbo-speed protection labels

The definition describes ip_fac_n_tcha_max_sp_prot_dif as a factor affecting reduction of the maximum turbocharger-speed setpoint with varying ambient pressure. Its declared input is amp, which the same file describes as ambient pressure measured or adapted. The label does not establish how much speed is permitted or whether an individual ECU selects this factor in a particular condition.

ip_fac_pred_n_tcha_prot is described as a turbocharger-speed prediction horizon for torque-based speed limitation; its input is labelled flow_tur_sp, described as flow through the turbine at setpoint. A different map, ip_tqi_n_tcha_max_sp_inc, is described as an increment of torque limitation for turbo-speed protection. Its inputs reference engine speed and n_tcha_max_sp_tran_dif, described as a transient difference between maximum turbo-speed setpoint and actual value for turbocharger protection. These names do not prove a particular calculation, physical measurement or active limiter. Verify the definition and signal source on the actual software.

Using the information in a log

COBB’s Mk8 monitor list illustrates why signal identity matters: its pre-CCF set explicitly calls turbine speed modelled, while its separate fast-logging list names turbo shaft speed and a maximum turbo-speed setpoint. A channel name alone does not establish that the connected car has a physical speed sensor, that a value is directly measured, or that its definition matches the A2L above.

Record ECU and calibration identifiers, turbo hardware, fuel, gear, ambient conditions and relevant fault data. Where the actual logger supports correctly defined signals, compare driver demand, torque requests and limits, pressure target and actual, ambient pressure, wastegate command and feedback, and turbo-speed data with its measurement or model status. A low request and a high request that is not achieved point to different investigations; a single speed or torque channel cannot prove which protection was active. Avoid copying another turbocharger’s speed limits or disabling a protection to conceal a fault.

For source-specific boost control and sensor-scaling context, see Simos 19 EA888 Evo4 boost and wastegate control. It is a separate tool and application example, not confirmation that its definitions match SCQ110.

Source and verification scope

Publicly indexed SCQ110_C_OEM.a2l: file metadata, characteristic descriptions, axis inputs and measurement descriptions reviewed 17 November 2026. The inspected file was 60,057,673 bytes; SHA-256 6473bf25107af882ebb3eea6cb0d57c223b2d005451df031ab546bfd1487f45e. This hash identifies the inspected text, not its authenticity, sharing rights, vehicle fit or behaviour.

COBB Engine Monitor List MK8 Vehicles. Product- and monitor-set-specific examples, not a definition for every 19.3 ECU. Accessed 17 November 2026.