Tuning Wiki
Applies to

Check the hardware and software limits stated in this article.

Scope: Volkswagen's SSP 522 describes switchable piston-cooling jets on its illustrated EA888 2.0 TSI with Simos 18.1. Hardware and control vary across applications. The calibration examples below are from the community SC8S5031_C_OEM reference; confirm the exact software, axes, units and selection before use.

What the system controls

Oil jets cool piston crowns when oil is routed to their gallery. In Volkswagen's example, ECU-controlled N522 operates a hydraulic switching arrangement; F447 monitors a pressure switch in the jet gallery. The ECU uses torque, engine speed and oil temperature in its control strategy. A pressure-switch state is not a continuous oil-pressure or piston-temperature measurement, and a commanded valve state alone does not establish oil flow. SSP 522, oil circuit and piston cooling.

The illustrated N522 is closed when de-energised, with the hydraulic arrangement routing oil to the jets; valve electrical state and jet flow therefore should not be treated as synonymous without the vehicle-specific circuit. Volkswagen notes that missing piston cooling can produce torque and speed limitation and prevent the low oil-pressure stage. Other systems may operate differently.

SC8S5031 control and diagnosis names

In the community ENLU actuator-control reference, “piston gating” refers to this oil-jet control context; it does not describe disabling engine cylinders.

  • ip_n_oil_2_pist_l_h: engine-speed threshold for activation of piston gating, in rpm, against oil temperature and filtered engine torque tqi_av_oil_2_pist in Nm.
  • ip_n_oil_2_pist_l_h_2: another engine-speed activation threshold, in rpm, against vehicle speed and filtered engine torque. Verify when this alternative contributes.
  • c_n_oil_2_pist_hys: engine-speed hysteresis for deactivation; c_fac_tqi_av_oil_2_pist_fil is a torque-filter factor. They are not jet-flow maps.
  • lv_oil_2_pist, n_oil_2_pist_l_h and tqi_av_oil_2_pist are runtime signals rather than calibration maps. Confirm actual signal polarity and diagnostic-tool naming for the target.
  • In the piston-gating plausibility reference, ip_n_toil_poil_pist and ip_n_toil_poil_pist_h are diagnostic speed thresholds against oil temperature; ip_t_toil_poil_pist_1 is a delay for a high oil-pressure request against oil temperature. They serve diagnostic logic and are not normal jet activation maps.

Investigation and validation

  1. Record engine and ECU identifiers, any oil-system modifications, oil temperature, codes and freeze-frame conditions. A modified turbo or higher load does not by itself determine a suitable jet map.
  2. Compare the cooling-jet command, F447 switch state, pump stage, rpm, load and temperatures when available. A switch mismatch can have electrical, hydraulic or mechanical causes; inspect the matching service information and verify oil supply before changing calibration.
  3. Use the manufacturer diagnostic procedures for wiring, valve and pressure tests. The switch monitors gallery pressure at its location; it does not individually confirm each jet's flow. A pressure request or actuator test alone is not proof of cooling effectiveness.
  4. Keep the oil-pressure, jet plausibility and torque/speed protections intact. Changing thresholds to hide a fault can leave a cooling or lubrication problem unresolved.

Related: oil pressure control · torque model calibration · turbocharger protection.

For measured, modelled and substituted oil-temperature signals and their calibration examples, see Simos 18 oil temperature sensing and modelling.