Tuning Wiki
Browse Renault Solex

The setup

The Super 5 GT Turbo (Supercinq overview) uses a 1397 cc Cléon-Fonte pushrod engine with a Garrett T2 turbocharger and an air-to-air intercooler, and is fed by a carburettor. Parts suppliers list a Solex 32DIS for the R5 Turbo and Super 5 GT Turbo, with its own insulator block and service kit, which differs from the 32DIS on the non-turbo R5 range. General carburettor method is on Carburettor tuning, jetting and setup.

Boost-sensitive enrichment

The carburettor has conventional full-load enrichment plus second and third enrichment stages that react when boost raises the pressure in the float chamber. The third stage is reported to come in at roughly 450 mbar, and how much extra fuel is needed depends on how much boost the engine runs. This description comes from enthusiast documentation rather than a Solex data sheet, so confirm the threshold against a parts diagram before relying on it.

Fuel pressure

  • When boost reaches the float bowl, the fuel supply pressure must stay above it. A margin of about 4 to 5 psi over boost is the commonly quoted rule of thumb for stopping fuel being pushed back out of the carburettor. It is an owner guideline, not a published specification.
  • An adjustable regulator is sold for these engines with a quoted range of 0.05 to 0.5 bar and a 1:1 boost reference. That range is the seller's claim.
  • Fuel evaporation and hard warm restarts are a known Phase 1 problem. Octane notes that Phase 2 added a small underbonnet fan to help.

Rebuild and wear

Gasket kits and base insulator blocks are sold for this carburettor, and step-by-step strip and clean guides exist. Worn spindles, a stuck choke or a failed gasket upset the boost-sensing behaviour, so rebuild before rejetting. See Carburettor synchronisation, faults and rebuilds for general method.

What is missing

No sourced jet sizes, emulsion tube numbers, air-corrector values or tuned-car jetting for the 32DIS were found. A rejet kit is mentioned in owner discussion but no values are given. Numbers should wait for a Renault workshop manual, a Solex data sheet or a documented dyno-tuned build. Validate any change with a wideband and a conservative boost limit.

Sources