Industrial V2 telemetry and data acquisition unit for remote reporting and logged data, subject to compatible cellular service and configuration.

Specifications and capabilities
V2 lists 10 Hz GPS standard, optional 20 Hz, CAN and serial communications, sensor inputs and a 64 MB buffer. Options and installed cellular hardware vary. Manufacturer specifications and documentation.
Data analysis software
The manufacturer says uploaded RT LIVE V2 recordings are stored as Race Technology .RUN files, compatible with its Analysis software; live monitoring requires the configured cloud connection and service. Manufacturer documentation.

Download Race Technology software for Windows. Check the current version and any licence or hardware requirements; some advanced functions require a unit-linked licence. See the Race Technology software overview for features and licensing.
Pinouts and cabling
The V2 front nine-way port is common to the Motorsport and Industrial V2 variants:
| Pin | Function |
|---|---|
| 1 | CAN low |
| 2 | RS232 1 RX |
| 3 | RS232 1 TX |
| 4 | RS232 2 TX |
| 5 | Ground |
| 6 | RS232 2 RX |
| 7 | Power output |
| 8 | CAN high |
| 9 | Not connected |
Industrial V2 uses a 25-way rear connector and separate two-pin LEMO power connector: pin 1 positive, pin 2 ground. The rear 25-way D-sub assignments below are transcribed from the manufacturer's labelled drawing. Verify the exact V2 Industrial model, numbered cavities and connector view before wiring; do not substitute the Motorsport rear connector map.
Manufacturer connection reference.
Check the connector number, version and options on the actual unit against the manufacturer's documentation before wiring. Disconnect power before changing connections.
Industrial V2 rear 25-way D-sub
Source: Race Technology RT LIVE V2 Industrial connection drawing. Labels are reproduced as shown; configure input types and confirm signal limits in the device instructions.
| Pin | Drawing label |
|---|---|
| 1 | ADC 1 |
| 2 | ADC 2 |
| 3 | ADC 3 |
| 4 | ADC 4 |
| 5 | ADC 5 |
| 6 | ADC 6 |
| 7 | ADC 7 |
| 8 | ADC 8 |
| 9 | RPM L |
| 10 | RPM H |
| 11 | iButton |
| 12 | Lap trigger |
| 13 | Status |
| 14–21 | Ground (each pin) |
| 22 | RPM ground |
| 23 | 5 V reference |
| 24 | Ground |
| 25 | Trigger |
Wiring overview
Return to the Race Technology manufacturer page.