Tuning Wiki

Sprintshift is Mercedes-Benz's automated manual transmission in the documented Sprinter application; it uses a mechanical geartrain with electronically controlled hydraulic actuation. Daimler service information SI26.00-D-0001A identifies transmission 716.643 in models 901.6, 902.6, 903.6 and 904.6. The vehicle's VIN, transmission and code GD5 must be checked before using the following examples. A similar 716.6 designation, relay appearance or gear lever does not establish identical service data for a passenger-car Sequentronic or a later Sprinter. Daimler SI26.00-D-0001A: Sprintshift oils; Daimler BT54.15-D-2601-01A: pump relay modification.

Separate the two oil systems

Daimler's 716.643 service note says the manual gearbox and Sprintshift hydraulic system are separate fill items, each with its own service specification. Its historical note also warns that replacement assemblies supplied through the parts channel were not necessarily delivered filled. That is not evidence that a particular replacement today arrives dry: check the part instructions and current workshop data. Never use a fluid or fill quantity from a different 716.6 variant simply because the gearbox name is similar. Daimler SI26.00-D-0001A.

For the hydraulic circuit, Daimler AR26.60-D-0009A prescribes model- and identification-dependent steps, specified equipment and a pressure check. The circuit can retain pressure and some components can move automatically. Use current service guidance to isolate and depressurise it; do not open a pipe or accumulator merely because the ignition is off. A correct static level reading cannot be assumed without the specified system state. Daimler AR26.60-D-0009A.

Pump relay history is VIN-dependent

Daimler's 2009 bulletin BT54.15-D-2601-01A describes different K84 relay and AK330 diode arrangements for particular VIN-ending ranges on the listed GD5 / 716.643 vehicles, including a changed relay arrangement intended to prevent hydraulic-pump damage. It differentiates factory installations, older configurations and the equipment already fitted. Check the complete bulletin and current Daimler parts information for the individual VIN and actual wiring; do not blindly fit a relay, diode or a modification copied from another range. Daimler relay modification bulletin.

Diagnostic approach

  1. Record the exact chassis, gearbox and control-unit identification, previous repairs, warning, selector and brake state, temperature and when the no-shift, take-up or pump complaint occurs. Save Sprintshift and other relevant fault memories before clearing them.
  2. For pressure or pump complaints, compare control-unit pressure feedback and pump command where available; check electrical supply, relay configuration and wiring, hydraulic fluid and external leakage using the exact model's prescribed checks. Frequent pumping or a no-shift warning alone does not distinguish pump, relay, accumulator, pressure sensor or an internal leak.
  3. For an unsuccessful shift with sufficient hydraulic supply, compare gear request, recognised position, clutch travel and speed inputs as available. Investigate actuator, feedback, electrical and mechanical faults on the evidence rather than assuming the gearbox itself is damaged.
  4. Follow the specific workshop procedure for any bleeding or control-unit learning after repair, and verify the original symptom. Active functions can move mechanisms; respect the manufacturer's precautions and load conditions.

The 716.643 hydraulic-service document also lists particular passenger-car 716.6 Sequentronic variants, but a shared document does not prove identical control strategies or interchangeability. See Mercedes 716.6 Sequentronic diagnosis and automated manual clutch and gearshift control.