Mainline DynoLog Dynamometers is an Australian maker of chassis dynamometers. Its ProHub family attaches to vehicle hubs; the company also offers roller dynos. The different machines, absorbers and control generations should be identified individually. See hub dynamometers and the manufacturers directory.

History
Mainline's company history says Mainline Automotive Equipment commenced trading in Australia in 1992 and manufactures Mainline DynoLog equipment in Sydney. A Mainline technical note dates the release of its ProHub series to 2014. The company also offers roller-chassis machines; ProHub is the hub-coupled family.
ProHub dyno models and loading
Portable ProHub 2WD CCS connects a vehicle's driven hubs to two absorber modules with hub adapters. The manufacturer lists 2000CCS and 3000CCS variants with eddy-current retarders. Each module resists shaft rotation; the wheel and tyre no longer contact a roller, while gearbox and differential losses remain part of the vehicle power path.
The ProHub AWD CCS range has four absorption modules and lists 3200CCS, 3600CCS and 4600CCS configurations. The maker also lists a ProHub Extreme 2WD family. Nominal ratings depend on configuration and operating speed: check the actual torque, power, duration, axle-load and speed curves instead of treating a headline horsepower value as the capability at every speed.
Controls and testing
Mainline describes its CCS as a CAN control system with Windows software, sensors and operator workstation. The cited ProHub pages describe steady-speed, fixed-load, ramp and road-load modes, with optional or configuration-dependent data channels. The controller commands the eddy-current brakes; it does not make the passive absorber motor the vehicle. Features and subscriptions vary with system generation and configuration.
Fitment and comparison
Confirm hub-adapter bolt pattern, allowable hub and axle loads, tyre clearance, electrical supply, cooling, calibration and axle synchronisation with Mainline. Vehicle axle speed, shaft torque and atmospheric correction should be reported with the method. This is hub output rather than a direct crankshaft measurement. Product information checked 17 November 2026 against the linked manufacturer pages.