Tuning Wiki

This guide covers HP Tuners airflow logging on the GM E38 controller, using owner cases from a 2009 GMC Sierra 5.3 and a 2014 Camaro SS LS3 manual with twin turbos. They are individual cases, not validated settings for every E38. Identify the ECU, operating system, sensors and engine modifications first; verify current tool support and use the vehicle's own original calibration. See the HP Tuners tool listing.

Fuel trims after a speed-density change

A Sierra owner reported long-term fuel trims around +18-20% after a speed-density change and asked how to log the virtual VE table. That observation does not establish the cause or justify adding that percentage to another engine. First check fuel pressure and injector data, intake leaks, sensor readings and the active airflow model. Check both banks and operating conditions where the ECU is actually trimming. 2009 Sierra owner discussion.

For supported GM coefficient-based calibrations, HP Tuners describes Edit > Virtual Volumetric Efficiency. Accurate injector characterisation is a prerequisite. Select the appropriate VE mode and cam angle; build a log over relevant RPM and load conditions, review fuel error and sample coverage, edit only justified areas, then use Calculate Coefficients before writing and rechecking. HP Tuners describes temporarily forcing speed density for its VE procedure on a MAF-equipped vehicle and restoring MAF operation afterwards. Mode availability and the means of selecting it depend on the operating system. HP Tuners: Virtual Volumetric Efficiency.

Separating MAF and VE measurements

In an E38 Holden HSV/Chevrolet SS worked example, a trainer measures airflow error against MAF frequency for the MAF curve and against RPM and manifold absolute pressure for virtual VE. The example uses separate operating modes to assess the models, then returns to combined operation. Match histogram units and breakpoints to the table, verify that the chosen channels are actually logging and compare commanded and independently measured lambda. Review cell counts, transients, intake temperature and coolant temperature before using a correction. Do not transfer the example's temporary switches, numbers or error values to another calibration without understanding them. HPA: E38 worked example; HP Tuners: table editor.

Fuel trims help only while the relevant closed-loop correction is active; they do not by themselves establish mixture under open-loop load. Use a suitable calibrated wideband and other instrumentation for the conditions being checked. HPA: VE and fuel-trim discussion.

Unstable idle after an engine change

The twin-turbo Camaro owner reported idle fluctuation after fitting larger injectors. Suggested checks were fuel trims, ignition timing, vacuum leaks and electronic throttle behaviour, and one reply distinguished the MAF curve from the speed-density table according to the active airflow method. No definitive repair was established. Treat this as a diagnostic sequence, not a recipe for idle settings. 2014 Camaro discussion.

Record diagnostic codes, save the original read, use stable power for flashing, and validate changes with fresh logs. If commanded and measured mixture diverge under load or fuel pressure falls, stop the test and investigate rather than relying on a borrowed tune.

Not established

The cause of the Sierra's high trims and the repair of the Camaro's idle instability are not documented.

Continue the conversation

If this topic interests you, consider joining the following forums. They host material referenced in this article.