Every piston engine leaks some combustion gas past the rings into the crankcase. How that gas is vented matters more once the engine makes more power and boost. This page explains the system and what changes on a modified engine. Carbon build-up in the intake is covered on carbon deposits and cleaning.
Blow-by
Blow-by is combustion gas that leaks past the piston rings into the crankcase. If it is not vented, it condenses with oil vapour into sludge and raises crankcase pressure, which can push oil past seals and gaskets (Wikipedia: Positive crankcase ventilation). Early engines simply vented these gases to the air, which caused pollution and odour. Modern engines route them back into the intake to be burned.
How a PCV system works
Manifold vacuum draws crankcase gas through a PCV valve into the intake. At idle, high vacuum makes the valve restrict flow so the mixture does not go lean. Under load or at high rpm, lower vacuum lets the valve open wider. The valve also works as a check valve and flame arrester, blocking intake pressure from entering the crankcase.
What boost and power change
- The intake can no longer draw the gas. A turbocharger or supercharger puts positive pressure in the intake under load, so the system must isolate the intake when it is pressurised. The route that vents the crankcase under boost differs from the route at idle.
- More blow-by. Higher cylinder pressures push more blow-by past the rings into the crankcase, so the same ventilation system has more to carry.
- Crankcase pressure. Positive crankcase pressure can damage seals and gaskets, and in extreme cases cause a crankcase explosion.
Cylinder pressure, ring seal and bore finish affect how much blow-by there is: pistons, connecting rods and rod bolts, cylinder bore preparation and honing and engine break-in after a rebuild.
Oil catch cans
An oil catch can is an aftermarket unit that pulls oil mist out of the crankcase vapour and collects it before it reaches the intake. It is used to reduce oil fouling the intake. The source describes it only as a way to reduce that fouling and does not assess how well any design works, so this wiki does not claim a power gain or a particular benefit for it. A catch can has to be plumbed so that it does not block the ventilation path, and the collected liquid needs emptying. Check that a modified breather arrangement still meets the emissions rules in your country, because venting crankcase gas to the air is generally not permitted on road vehicles. Check the legal position with a qualified local provider.
When the system fails
- Crankcase pressure builds, causing oil leaks and gasket failure.
- Sludge forms in the crankcase.
- Oil-laden blow-by contaminates the intake air and builds carbon in the intake manifold.
- On direct-injection engines, fuel does not wash the intake valves, so carbon on them is not cleaned by fuel additives; removal is by spraying cleaner through the intake or media blasting.
Oil in the intake after a power upgrade is therefore a reason to check the ventilation and the rings, not only to fit a catch can: compression and leak-down testers and common petrol engine problems.
Checks
- Check hoses, valves and breather connections for blockage, splits and incorrect routing, to the vehicle maker's diagram.
- Look for oil weeping at seals and gaskets after a power increase, which suggests crankcase pressure.
- Check that the intake isolation works under boost, so the crankcase is not pressurised by the intake.
- Measure blow-by with a leak-down test if consumption or pressure is high.
Sources
- Positive crankcase ventilation. Wikipedia. Blow-by, PCV operation, boost issues, catch cans and failure effects. The article flags some claims as weakly sourced; those are not relied on here. Accessed 2026-11-19.